Overland Vehicle Systems 18199909 Installation guide

CAR SIDE SHOWER

CAR SIDE SHOWER
SET UP & CARE INSTRUCTIONS
NOTE: Your shower tent can be mounted directly to the side of a roof cage by simply drilling four
6.5mm holes into the side supports and aaching using the bolts and nylon nuts supplied.
Alternavely, you can use the supplied ‘L’ brackets and mounng hardware in the various
conguraons shown below.
The shower tent can now be aached to a roof rack or roof bar as shown in the following diagrams.
IMPORTANT: In some cases, 6.5mm holes will need to be drilled to aach brackets
IMPORTANT!
Before mounting your shower tent make
sure that it clears the door openings, lift up
tailgate, aerials or other obstructions on
the vehicle.

CAR SIDE SHOWER
SET UP & CARE INSTRUCTIONS
1
2
Unzip weather resistant cover and release the
Velcro straps, allowing the fabric to be released.
Move the arms outwards and lock in place.

CAR SIDE SHOWER
SET UP & CARE INSTRUCTIONS
3
4
5
Unfold the fabric and allow it to hang, adjust the
webbing straps at the top to achieve the required
height from the ground.
Peg out the four corners and tension the webbing
straps as required.
The car side shower should be ready.
For pack up: Care and Maintenance
When it is me to pack up, check that fabric is dry
and free from dirt and debris then reverse the set
up process.
If your shower tent has been packed up wet or has
become damp, we recommend that it be aired out
to prevent mold, mildew or staining of the material.
If your shower tent requires cleaning. We recom-
mend to use lukewarm soapy water and a clean
sponge to wipe down the material. Do not use
abrasive cleaners or bleach.
For any further quesons, please contact
Overland Vehicle Systems at 833.226.4863 or visit
www.overlandvehiclesystems.com