Oypla GARDEN 2459 User manual

30L Water Filled Lawn
Roller
User Manual
USER MANUAL Model No: 2459
User Manual

USER MANUAL Model No: 2459
Make sure all bolts are secured before using. The user takes all responsibility for the
construction and use of the product.
Please make sure that the plug (found on the side of the 30L tank) is secure once you
have filled the tank with water. If the plug isn’t secure it could dislodge itself and
cause the water to escape.
Leaving the product outside exposed to weather, especially direct sun, rain and salt
air, will speed the weathering process. This can be slowed by removing the product
from these conditions, or covering it with a suitable cover.
This product is not a toy, and is only to be used for its designated purpose.
Do not carry out alterations or modifications to this product.
This product is intended for outdoor use only.
Clean only with a damp cloth. Do not use strong industrial cleaning substances.
If the product is damaged or has any defects, please contact [e-mail]
30KG WHEN FILLED WITH WATER
45KG WHEN FILLED WITH SAND
Safety Instructions
Notice: Ensure you read and fully understand instructions before use
While every attempt is made to ensure the highest degree of protection in all equipment, we cannot
guarantee freedom from injury. The user assumes all risk of injury due to use. All merchandise is sold on
this condition, which no representative of the company can waive or change.

Part
Part Name
Quantity
Part
A
30L Tank
1
B
Roller Handle
1
C
Scraper Bar
1
D
Roller Beam
2
E
Screw
6
F
Nut
6
Assembly Instructions
Parts List:
If you are missing any of the below parts please contact cservi[email protected]m
Please be aware that you will be referring to this parts list throughout the assembly process.
USER MANUAL Model No: 2459

USER MANUAL Model No: 2459
2. Align the holes in the Scraper Bar (C) with
the hole in the roller beams (D). Once done,
push a screw (E) through each hole to hold
the scraper bar in place. After this tighten a
nut (F) onto the screw (D). Do not
overtighten the nut as this may damage the
roller beams due to the curve in the metal.
Please see the images above.
1. To start, push the bottom of the roller
beams (D) into the 30L tank (A), ensuring
that they go all the way in. This will allow for
the roller beams to be secure when you
attach the scraper bar. Please see the image
to the right.
3. Slide the roller handle (B0 on the inside of the
roller beams (D), ensuring that the roller handle
(B) is directly against the inside of the roller
beams (D). Once done, push a screw (E) through
each hole, ensuring it goes through both parts.
Once done, tighten a nut (F) onto the screw (D).
Do not overtighten as this may cause the screw
to bend. After this, repeat this step to fully
attach the handle.

USER MANUAL Model No: 3115
USER MANUAL Model No: 3115
USER MANUAL Model No: 2459
Please retain a copy of all instructions for future
consultation.
Imported into the EU by Oypla.com LLP, Uxbridge, UB8 2FX