Oypla GARDEN 2459 User manual

30L Lawn Roller
User Manual
USER MANUAL Model No: 2459
User Manual

USER MANUAL Model No: 2459
Make sure all bolts are secured before using. The user takes all responsibility for the
construction and use of the product.
Please make sure that the plug (found on the side of the 30L tank) is secure once you
have filled the tank with water. If the plug isn’t secure it could dislodge itself and
cause the water to escape.
Leaving the product outside exposed to weather, especially direct sun, rain and salt
air, will speed the weathering process. This can be slowed by removing the product
from these conditions, or covering it with a suitable cover.
This product is not a toy, and is only to be used for its designated purpose.
Do not carry out alterations or modifications to this product.
This product is intended for outdoor use only.
Clean only with a damp cloth. Do not use strong industrial cleaning substances.
If the product is damaged or has any defects, please contact [email protected]
30KG WHEN FILLED WITH WATER
45KG WHEN FILLED WITH SAND
Safety Instructions
Notice: Ensure you read and fully understand instructions before use
While every attempt is made to ensure the highest degree of protection in all equipment, we cannot
guarantee freedom from injury. The user assumes all risk of injury due to use. All merchandise is sold on
this condition, which no representative of the company can waive or change.

Assembly Instructions
Parts List:
If you are missing any of the below parts please contact [email protected]
Please be aware that you will be referring to this parts list throughout the assembly process.
USER MANUAL Model No: 2459

Do not tighten fixings until all nuts, bolts and washers are in the correct position
1. Assemble the left arm by attaching the lower arm section to the handle (2) using two bolts (5) and
secure in place using a washer (6) and nut (7).
2. Repeat this process with the right arm.
3. Attach the arms to the drum axle using the axle bolts (8)
4. Attach the scraper bar (4) to the arms using a bolt, washer and nut (5, 6, 7) on each side.
5. Check the handle is square and the cross bar/scraper is not touching the roller drum and then tighten
all the fixings.
6. Turn the roller drum so that the cap is upwards and then fill with water or sand.
Imported by Oypla.com LLP, Uxbridge, UB8 2FX
USER MANUAL Model No: 2459