Oypla GARDEN 3964 User manual

User Manual
USER MANUAL Model No: 3964
90L Square Garden
Incinerator

•Please note that the edges of the metal are sharp. Be careful when removing the
protective film before assembly and use.
•Do not use the garden incinerator when there are high winds as this will increase
the smoke output and possibly create a nuisance to others around.
•Ensure your garden incinerator is on a firm and level surface to minimise any risk
of it falling over, especially when it is hot.
•Wear thick gloves, long sleeves, strong shoes and eye protection to protect against
any potential incidents.
•Do not burn plastic, flammable gases or liquids, pressurized containers or
batteries, this product is designed for garden waste ONLY. For example, dry
organic material.
•Do not leave unattended when hot.
•Please keep both children and pets away at all times.
•Let the product cool completely before attempting to move or touch.
•Do not use in small spaces.
•If the product is damaged or has any defects, please contact cs[email protected]
•
Safety Instructions
Notice: Ensure you read and fully understand instructions before use
While every attempt is made to ensure the highest degree of protection in all equipment, we cannot
guarantee freedom from injury. The user assumes all risk of injury due to use. All merchandise is sold
on this condition, which no representative of the company can waive or change.
USER MANUAL Model No: 3964

Long
Side
Bracket
4pcs
Metal
Side Panel
4pcs
Short Top
Bracket
4pcs
Rack Lid
1pc
Handle
1pc
Nuts (for
handle)
1pc
Bottom
Panel
1pc
Pair of
Nuts and
Bolts
45pcs
USER MANUAL Model No: 3964
Assembly Instructions
Parts List:
Please check you have all parts below before attempting to assemble this product.
If you are missing any of the below parts, please contact Oypla customer services:
[email protected]om

Step 1:
Attach the long side bracket to the metal side panels using 4 bolts
and 4 nuts. Repeat for remaining panels and brackets.
Step 2:
Attach the side brackets and panels units
using the bolts and nuts
Step 3:
Attach the short top brackets using 3
bolts and 3 nuts. Attach to the centre
hole near the long bracket. Repeat
process for the remaining three.
USER MANUAL Model No: 3964

USER MANUAL Model No:
USER MANUAL Model No: 3964
Please retain a copy of all instructions for future
consultation.
Imported into the EU by Oypla.com LLP, Uxbridge, UB8 2FX
Step 4:
Attach the handle to the rack lid with the nut.
Step 5:
Place the bottom panel inside, on the base.
To light the incinerator. First line the bottom of the garden incinerator with newspapers and small twigs.
Light the newspaper and allow a bit of time to heat up, while adding larger branches.
Then you can add your garden rubbish into the incinerator, and place the metal rack on top, using the
handle.