OYPLA Home 3831 User manual

User Manual
USER MANUAL Model No: 3831
3 Tier Clothes Airer

Never carry out any alterations or modifications to this product.
This product is not a toy, and is only to be used for its designated purpose.
This product is intended for indoor use only.
Keep fingers, loose clothing and hair away when folding the product.
Make sure that the product is in an open space.
Leaving the product outside exposed to weather, especially direct sun (for
extended periods of time), rain and salt air, will speed the weathering process. This
can be slowed by removing the product from these conditions, or covering it with
a suitable cover.
Clean only with a damp cloth. Do not use strong industrial cleaning substances or
abrasive materials as these will damage the product.
If the product is damaged or has any defects, please contact [email protected]
USER MANUAL Model No: 3831
Safety Instructions
Notice: Ensure you read and fully understand instructions before use
While every attempt is made to ensure the highest degree of protection in all equipment, we cannot
guarantee freedom from injury. The user assumes all risk of injury due to use. All merchandise is sold on
this condition, which no representative of the company can waive or change.

Assembly Instructions
Figure
Description/OTY
Photo
1
Base Supports (x2)
2
Wheels (x4)
3
Base Poles (x2)
4
Short Thin Poles
(x6)
5
Longer Thin Poles
(x18)
6
Short Thick Poles
(x12)
7
Hex Shaped Screws
and Nuts (x4)
8
Bolts (x12)
9
Top Connector (x2)
Parts List:
If you are missing any of the below parts please contact cservic[email protected]
Please be aware that you will be referring to this parts list throughout the assembly process.
USER MANUAL Model No: 3831

10
Middle Connectors
(x4)
11
Top Pole Cover
(x2)
12
Right Side Shelf
Arms (x5)
13
Left Side Shelf Arm
(x5)
14
Hanging Arm (x2)
1) Firstly, insert the 2 base poles (3) into the inner side
holes of the base supports (1). Then using some
pressure push each wheel into holes on the underside
of the base supports. See photos for assistance.
2) Secondly, insert 4 short thick poles (6) into the top holes
of the base supports (1). Then on either side, attach 2
middle connectors (10) which are joined by 2 short thin
poles (4) which attach into the inner side holes of the
middle connectors (10). Please see photos for help.
USER MANUAL Model No: 3831

3) Now, it’s time to assemble the shelves. To start, take
1 right and left sided shelf arm (12 & 13) and push into
each end of the middle connector (10) (Ensure the
pointed end is facing upwards) . Secure in place using 1
bolt (8) for each arm. Repeat on the other side. See
photos for assistance.
4) Next, take 6 longer thin poles (5) and slide horizontally
into the inner holes of the shelf arms. It is easier so start on
the inside and work outwards.
5) Repeat steps 2, 3 and 4 2 more times until there are 3 tiers.
For the top tier, ensure you use the top connectors (9) instead
of middle ones as these require the four hex shaped screws
and nuts (7) to secure in position. Leave some pole space
above the top connector and attach the top pole covers (11)
followed by the hanging arm on top.
Imported by Oypla.com LLP, Uxbridge, UB8 2FX
USER MANUAL Model No: 3831