OYPLA Home 3946 User manual

Coat Stand & Shoe Rack
User Manual
USER MANUAL Model No: 3946, 4585

Safety Instructions
Notice: Ensure you read and fully understand instructions before use
While every attempt is made to ensure the highest degree of protection in all equipment, we cannot
guarantee freedom from injury. The user assumes all risk of injury due to use. All merchandise is sold on
this condition, which no representative of the company can waive or change.
•This product is intended for indoor use only. Only use on a stable and level ground.
•Do not carry out alterations or modifications to this product.
•This product contains small parts that could be a choking hazard if swallowed. Keep
these items away from children.
•Do not discard any of the packaging until you have checked that you have all the parts
and fittings required.
•Leaving the product outside exposed to weather, especially direct sun and rain, will speed
the weathering process. This can be slowed by removing the product from these
conditions, or covering it with a suitable cover.
•Make sure all fastenings are tightly in place and that everything is in order before using
the product. This should be checked periodically by an adult.
•Use the correct fixings as indicated. Do not tighten any of the nuts until the unit is
completely assembled, then finish by tightening all nuts. All nuts must be tightened before
use.
•Keep away from fire.
•Clean only with a damp cloth. Do not use strong industrial cleaning substances.
•If the product is damaged or has any defects, please contact [e-mail]
USER MANUAL Model No: 3946, 4585
3946

Assembly Instructions
Parts List:
If you are missing any of the below parts please contact [email protected]om
Please be aware that you will be referring to this parts list throughout the assembly process.
Top Rail
1
Tube Plugs
2
Upper Pole
2
Coat
Hangers
2
Lower Pole
2
Shelves
3
Support
Frames
2
Feet
4
Screws
6x35
20
Screws
6x10
4
USER MANUAL Model No: 3946, 4585

Please note that the support frames are not identical. The screw recesses should be pointing outward.
When installing the upper poles, firstly install the coat hangers, ensuring that they are symmetrical and
correctly aligned. Finally insert the fully assembled upper poles and coat hangers into the lower poles.
Install from the bottom up. Ensure that all the framework is correctly assembled and aligned before fully
tightening the screws.
Step 1:
Step 2:
Step 3:
Imported by Oypla.com LLP, Uxbridge, UB8 2FX
USER MANUAL Model No: 3946, 4585