Oypla 3034 User manual

Luxury Office
User Manual
USER MANUAL Model No: 3034

DO NOT EXCEED THE 175KG WEIGHT LIMIT
Safety Instructions
Notice: Ensure you read and fully understand instructions before use
While every attempt is made to ensure the highest degree of protection in all equipment, we cannot
guarantee freedom from injury. The user assumes all risk of injury due to use. All merchandise is sold on
this condition, which no representative of the company can waive or change.
•This product should only be used for its designated purpose.
•This product is intended for indoor use only.
•Do not carry out alterations or modifications to this product.
•This product contains small parts that could be a choking hazard if swallowed. Keep
these items away from children.
•Do not discard any of the packaging until you have checked that you have all the
parts and fittings required.
•Make sure all fastenings are tightly in place and that everything is in order before
using the product. This should be checked periodically by an adult.
•When rolling the chair, be sure that there are no obstacles in the way.
•Take care when adjusting the height and the back support.
•Only use on a stable and level ground.
•Use the correct fixings as indicated. Do not tighten any of the nuts until the unit is
completely assembled, then finish by tightening all nuts. All nuts must be tightened
before use.
•Keep away from fire.
•Clean only with a damp cloth. Do not use strong industrial cleaning substances.
•If the product is damaged or has any defects, please contact cs[email protected]
USER MANUAL Model No: 3034
DO NOT EXCEED THE 175KG WEIGHT LIMIT

Assembly Instructions
USER MANUAL Model No: 3125
Parts List:
If you are missing any of the below parts please contact [email protected]
Please be aware that you will be referring to this parts list throughout the assembly process.
USER MANUAL Model No: 3034

USER MANUAL Model No: 3748USER MANUAL Model No: 3518USER MANUAL Model No: 3034
1. Lay the chair base on the floor, ensuring that the
bottom of the chair base is facing upwards. After this,
push a wheel into the chair base, ensuring the spike on
the wheel lodges into the chair base. Repeat this for the
remaining wheels. Please see the image to the left.
2. Push the support pole into the hole in the centre of the chair base. After you’ve done this, place the support
pole cover over the support pole. Please see the images above.
3. Place the adjustment platform on the bottom of
the chair seat, ensuring the holes on the adjustment
platform line up with the holes on the chair seat.
Once done, secure the adjustment platform in place
by using the small screws (M6X25). Please see the
image to the right.
4. To attach the chair back support to the chair seat, align
the holes on the metallic section of the chair back
support with the holes on the adjustment platform.
Once done, secure the chair back support in place with
the regular screws (M6X30). Make sure the screws are
tightened correctly. Please see the image to the left.

USER MANUAL Model No: 3034
5. Align the holes in a chair arm with the holes in a side of the chair. After this, insert a large screw (M6X55)
into the both available points. Tighten these until the chair arm is completely still. Push a screw cover into
the hole. Repeat this process on the other side to complete the upper section of chair. Please see the images
above.
6. Slide the completed chair onto the support pole,
ensuring it locks into the adjustment platform. Once
done, apply some weight to the chair to see if the
support pole is correctly locked into place. After the
chair is fully constructed, make sure to check that is
safe to use. Please see the image to the left.
Please retain a copy of all instructions for future
consultation.
Imported into the EU by Oypla.com LLP, Uxbridge, UB8 2FX