Oypla 4537 User manual

User Manual
USER MANUAL Model No: 4537
Traffic Mirror

Make sure all fastenings are tightly in place and that everything is in order before
using the product. This should be checked periodically by an adult.
Do not discard any of the packaging until you have checked that you have all of
the parts and fittings required.
Use the correct fixings as indicated. Do not tighten any of the nuts until the unit is
completely assembled, then finish by tightening all nuts. All nuts must be
tightened before use.
Do not carry out alterations or modifications to this product.
Persons (including children) with reduced physical, sensory and mental capacities
or lack of experience and knowledge do not intend this product for use, unless
persons responsible for their safety have given them supervision or instruction
concerning use of the product.
If the product is damaged or has any defects, please contact cs[email protected]
Safety Instructions
Notice: Ensure you read and fully understand instructions before use
While every attempt is made to ensure the highest degree of protection in all equipment, we cannot
guarantee freedom from injury. The user assumes all risk of injury due to use. All merchandise is sold
on this condition, which no representative of the company can waive or change.
USER MANUAL Model No:
USER MANUAL Model No: 3133
USER MANUAL Model No: 4537
Operating Instructions

Please retain a copy of all instructions for future
consultation.
Imported into the EU by Oypla.com LLP, Uxbridge, UB8 2FX
USER MANUAL Model No: 4537
Assembly Instructions
Parts List:
Please check you have all parts below before attempting to assemble this product.
If you are missing any of the below parts, please contact Oypla customer services:
[email protected]om
1. Fasten the L-Shape parts onto the back of the mirror with screw bolts provided.
Make sure the curved hole is close to the bottom.
2. Connect the mounting bracket to the pole with the screw bolts provided. Adjust it
to the required position and then tighten screws until the mounting bracket is firm
on the pole.
3. Connect the L-Shape Parts to the hold hoops with the screw bolts provided.
Tighten all of the bolt screws after you have adjusted the mirror to the right
position and angle.