
6
Leisure-Lift POWER WHEELCHAIR TIE DOWN INFORMATION
WARNING: Do not engage in the following activities with your power wheelchair
or serious injury may result.
Do not remain seated on your power wheelchair while it is being loaded into a ve-
hicle using anything other than a special wheelchair lift.
Riding on a platform lift is dangerous. Failure to check weight capacity, turn off con-
troller, have the required precise driving control capability or have the wheelchair
properly maintained could result in serious injury or death.
Do not use the power wheelchair as a seat in a moving vehicle. As of this date, the
Department of Transportation has not approved any tie down system for transporta-
tion of a user while in a power wheelchair in a moving vehicle of any type. The rider
must be seated in a regular automotive seat and restrained by an approved automobile
safety belt. The rider must be warned that there is a many times greater likelihood of
sever injury or death in the event of an accident if they are not in the provided automo-
tive seat and restraint system. The following attachment points are provided for the
sole purpose of securing the mobility device without the rider. The power wheelchair
and batteries MUST be independently and properly restrained or stored in a separate
compartment so as to prevent it from causing injury in an accident.
CONVENIENT TIE DOWN POINTS
The following is a list of convenient locations that the straps from a 4 point secure-
ment system could be anchored on PaceSaver products. These products have not been
crash tested and certied as crash worthy using these locations.
POWER WHEELCHAIRS
M1 FRONT WHEEL DRIVE
Back anchor points - Place a strap around the lower portion of each armrest support.
Front anchor points - Place a strap around each anti-tip wheel support arm just above
the small anti-tip wheel.
M1 REAR WHEEL DRIVE
Back anchor points - Place a strap around the lower portion of each armrest support.
Front anchor points - Place a strap around the top of each swivel caster fork.
SCOUT, SCOUT RF, SCOUT RF 4, BOSS 4.5, BOSS 6, BOSS 6NS, BOSS 6.75
Back anchor points - Place a strap around the lower portion of each armrest support.
Front anchor points - Place a strap around each anti-tip wheel support arm just above
the small anti-tip wheel.