© Pan Acoustics GmbH V 1.0 Page 5 of 22
Manual
4. General Safety Regulations
The following safety regulations must be read completely and diligently before putting the device
into operation and must then be kept in a safe place near the device. Reading the manual does not
replace the knowledge and observance of all valid local safety rules and regulations. The information
and technical speci cations published in this document are based on data available at the time of
publication. We reserve the right to make changes to the product aimed towards product improvement
and adjustment to new applicable standards.
To prevent electric shock,
• the product must not be connected to the mains power supply when the enclosure is open.
• the product must only be used with intact power cords.
• the product must only be connected to a mains power supply if the mains voltage matches the
voltage indicated on the device.
• the product must only be mounted and xed when disconnected from the mains power supply.
• one must never pull on the cord, but only on the plug when unplugging the device.
• no objects must be placed on top of the power cord of the device.
• the power cords must be installed in such a way that they are protected from damage due to foot
traffi c, pinching and tensile stress.
• it must be ensured that all devices connected to each other via signal lines are operated with earthed
sockets on a common protective earth.
To minimise the risk of re or electric shock,
• the product must not be exposed to moisture or humidity.
(Exception: versions with an appropriate IP protection class).
• no objects lled with liquid (e.g. bottles) must be placed on top of the device.
• ventilation slots must not be covered up with objects (e.g. textiles).
• the device must not be exposed to excessive heat, direct sunlight, re or the like.
• no open re sources (e.g. candles) must be placed on top of the device.
To prevent injury, this product must be taken out of operation, clearly marked and secured against
accidental operation if the product
• shows signs of visible damage.
• contains loose parts.
• no longer works awlessly.
• has been stored for a long time under unfavourable conditions (e.g. in humid rooms).
• was exposed to severe transport stress (e.g. with unsuitable packaging).
To avoid damage to the device and injury,
• this product must be kept out of the reach of children.
• the product must be installed in a stable position.
• only accessories o ered and approved by Pan Acoustics for the product must be used for mobile
applications and xed installations.
To avoid injuries such as hearing damage due to excessive volume levels, persons should
• never stand directly in front of a connected loudspeaker.
• not be exposed to high volume levels over a long period of time.
The device conforms to protection class 1 – protective earthing. For safety reasons, the device must
only be operated on a properly installed socket with earth contact. The earth contact connection
must never be disconnected. The voltage of the mains power supply must match the rated voltages
indicated on the device. To prevent injuries, electric shock and re, ensure that all persons involved
in the set up, operation, dismounting or installation of the device / system have read this manual.
