Panasonic AK-HDC931 User manual

Installing the board in a Multi-Format Camera
1Remove the left and right side panels on the Multi-Format Camera (AK-HC931P).
2Remove the blank panel (right side of camera), then feed the cable (supplied with the
board) through the rectangular opening under the top panel and insert it into the
connector on the opposite side.
578
DOWN
CONV
Down Converter Board
Model No. AK-HDC931P
Blank panel
Heat sink
Connector
Insert the cable into the connector on the opposite
(left) side of the camera(inside of the heat sink).
Rectangular opening
CAUTION:
These servicing instructions are for use by qualified service personnel only. To
reduce the risk of electric shock do not perform any servicing other than that
contained in the operating instructions unless you are qualified to do so.

6
56
DOWN
CONV
78
3Insert this board (down converter unit) into slot 6 of the camera’s circuit board.
4Insert the other end of the cable into the connector on the board itself.
Printed in Japan
VQT0B70 F0902H0-5@3
Down converter board
5678
DOWN
CONV