Panasonic RC-7200P User manual

ORDERNO. AD0303076C1
J1
FM-AMClock Radio
RC-7200P / RC-7200PC / RC-7150P / RC-7150PC
Colour
(S)............Silver Type
SPECIFICATIONS
Specification
1

Radiofrequencyrange:
FM; 88.0-108.0MHz
AM; 525-1710 kHz
Intermediatefrequency:
FM; 10.7MHz
AM; 455.0kHz
Sensitivity:
FM; 6.31 V/50mWoutput (-3dB
limit sens.)
AM; 100 V/m/50mWoutput (Max
sens.)
Power requirement:
AC; 120 V, 60 Hz / Power
consumption; 6W
Battery; 9V (one6F22/6LR61, 006P
battery)
Speaker: 4cm (1-1/2”)
Dimensions(W×H×D): 215×64×149 mm / (8-7/16”×2-9/
16”×5-7/8”)
Mass (without battery): RC-7200; 781g(1lb. 12oz.) / RC-
7150; 768g(1lb. 12oz.)
Note: / Specificationsare subject tochangewithout notice. /
Mass and dimensionsare approximate.
[Power consumption instandbymode: 1.5W]
2003 Matsushita ElectricIndustrial Co., Ltd. All rights reserved.
Unauthorized copying and distribution isaviolation of law.
1. Safety Precaution
(This “SafetyPrecaution” is appliedonlyinU.S.A.)
2

1. Before servicing, unplug the power cord to prevent an electric
shock.
2. When replacing parts, use onlymanufacturer’srecommended
components for safety.
3. Check the condition of the power cord. Replace ifwear or damage
isevident.
4. After servicing, be sure to restore the lead dress, insulation
barriers, insulation papers, shields, etc.
5. Before returning the serviced equipment to the customer, be sure
to make the following insulation resistance test to prevent the
customer from being exposed to ashock hazard.
Insulation Resistance Test
1. Unplug the power cord and short the twoprongs of the plug with
ajumper wire.
2. Turn on the power switch.
3. Measure the resistance value with ohmmeter between the jumper
AC plug and each exposed metal cabinet part, such as screw
heads, control shafts, handlebrackets, etc. Equipment with
antenna terminalsshouldread between 3M and 5.2M to all
exposed parts. (Fig. A) Equipment without antenna terminals
shouldread approximatelyinfinityto all exposed parts. (Fig. B) / *
Note: Some exposed parts maybe isolated from the chassisby
design. These will read infinity.
(Fig. A)
3

(Fig. B)
4

4. Ifthe measurement isoutside the specified limits, there isa
possibilityof ashock hazard. The equipment shouldbe repaired
and rechecked before itisreturned to the customer.
2. Replacement Parts List
Ref.No. Part No. Part Name &
Description PcsRemarks
A1 RQTW0037
-P O/I BOOK 1 English
A1 RQTW0038
-C O/I BOOK 1 (PC) Canadian
French
3. Schematic Diagram
4. Schematic Diagram for printing with letter size
K0303YH
5