9
Getting Started
6 Setup Windows.
Follow the on-screen instructions.
lThe computer restarts several times. Do not touch the keyboard or touch
pad, and wait until the drive indicator has turned off.
lAfter the computer is turned on, the screen remains black or unchanged for
a while, but this is not a malfunction. Wait for a moment until the Windows
setup screen appears.
lDuring setup of Windows, use the touch pad and clicking to move the pointer
and to click an item.
lSetup of Windows will take approximately 5 minutes /
20 minutes.
Go to the next step, conrming each message on the display.
lYou can set the Wireless Network after the setup of Windows is complete.
If “Get online” is displayed, select “Skip this step”.
“Join a wireless network” screen may not appear.
CAUTION
lYou can change the user name, password, image and security setting after
setup of Windows.
lRemember your password. If you forget the password, you cannot use Win-
dows. Creating a password reset disk beforehand is recommended.
l Do not use the following words for user name: CON, PRN, AUX, CLOCK$, NUL,
COM1 to COM9, LPT1 to LPT9, @. In particular, if you create a user name (ac-
count name) that includes the “@” mark, a password will be requested at the
log-on screen, even if no password has been set. If you try to log on without en-
tering a password, “The user name or password is incorrect.” may be displayed
and you will not be able to sign in / log on to Windows
(èpage 20).
7 Create the recovery disc.
A recovery disc allows you to install OS and restore its factory default condition,
in case, for example, the recovery partition of the HDD is damaged.
We recommend creating a recovery disc before you begin using the computer.
Refer to Reference Manual “Recovery Disc Creation Utility” about creating
the disc.
NOTE
lPC Information Viewer
This computer periodically records the management information of the hard disk, etc. The maximum data volume
for each record is 1024 bytes.
This information is only used for estimating the cause when the hard disk goes down by any possibility. They are
never sent to outside via network nor used for any other purpose except for the purpose described the above.
To disable the function, add the check mark for [Disable the automatic save function for management information
history] in [Hard Disk Status] of PC Information Viewer, and click [OK].
(èReference Manual “Checking the Computer’s Usage Status”)
nBefore using wireless function
ASlide the wireless switch to ON.
B Display “Charm” and click - [Change PC Settings] - [Network] - [Airplane mode].
Set [Wi-Fi] to [On] (for wireless LAN).
set [Mobile broadband] to [On] (for wireless WAN).
set [GPS] to [On] (for wireless WAN).
set [Bluetooth] to [On] (for Bluetooth).
set [GPS\GNSS] to [On] (for GPS).
