Operating Instructions
(Household use) Shaver Head
Model No. ER-CSF1
ER-CSF1
Safety precautions
Follow these instructions.
To prevent accidents, injuries or damage to property, please follow the
instructions below.
The following chart indicates the degree of damage caused by
improper operation.
Indicates potential hazard that could result in serious
injury or death.
Indicates potential hazard that could result in minor
injury or property damage.
WARNING
Preventing accidents
• Do not place within reach of children or infants. Do not let them
use it.
-Putting parts or accessories in the mouth may cause an accident or
injury.
CAUTION
Protecting the skin
• Do not use excessive pressure to apply the system outer foil to
your lip or other part of your face.
• Do not apply the system outer foil directly to blemishes or Injured
skin.
• Do not touch the blade section (metallic section) of the inner blade.
-Doing so may cause injury to skin or hand.
• Do not use this appliance for hair on head or any other part of the
body.
-Doing so may damage the foil causing injury to skin or reduce the life of
the system outer foil.
• Check the system outer foil for cracks or deformations before use.
-Failure to do so may cause injury to the skin.
• Do not forcefully press the system outer foil.
in use.
-Doing so may damage the foil causing injury to skin or reduce the life of
the system outer foil.
Note the following precautions
• Do not share with your family or other people.
-
Important information
• Apply the lubrication oil after each cleaning for it will keep the movement of
the blade smooth and maintain a comfortable shave.
• Note the following precautions to avoid malfunction or deformation.
• Do not bring the system outer foil into contact with hard objects.
• Do not drop or hit against other objects.
• Store the appliance in a place with low humidity after use.
• Be sure to place the protective cap on the head when carrying around or
storing.
Parts identification (Fig. 1)
AHead
1Protective cap
2System outer foil
3Foil frame
4System outer foil release buttons
5Outer foil section
6Inner blades
7Foil frame release button
How to use
• Clean the appliance after use.
1 Mount the head to the main body until it clicks.
2 Turn on the power.
Note
• The use time after a full charge is as follows.
ER-CBL1: Approximately 50 minutes
ER-CBN1: Approximately 40 minutes
(Based on dry using at 20 °C - 30 °C)
The operating time may differ depending on the frequency of use and the
operating method.
Quick charge (ER-CBL1 only)
Even though the battery runs out, you can use for 5 minutes after
3-minute charge.
(This will differ depending on usage.)
Removing and mounting the head (Fig. 2)
• Make sure that the main body is turned off.
Remove the head while pushing the head release button (a).
Stand the head when it is removed.
Mount the head to the main body until it clicks.
Shaving (Fig. 3)
Apply the whole system outer foil perpendicularly against the skin and shave
by slowly gliding the appliance over the face against the grain of the beard.
• The beard under the chin and around the throat can be shaved better by
stretching the skin to raise the beard.
• To prevent damaging the system outer foil, do not shave with only a part of
the system outer foil.
•
-
•
•
•
-
•
-
•
-
•
-
•
-
•
•
•
•
•
•
(
A
1
2
3
4
5
6
7
•
•
:ER-CBL1
:ER-CBN1
ER- CBL1
.
(
•
.(a
(
•
•
English
ER9210CSF12221_EN-AR.indd 1
ER9210CSF12221_EN-AR.indd 1
31/3/2566 BE 16:59
