Panasonic Toughbook CF-U1AQB1G2M Wiring diagram

First-time Operation
Supplementary Instructions
for 2D Barcode Reader
Personal Computer
Model No. CF-U1 Series
Contents
Precautions .................................................................. 2
Names and Functions of Parts .................................. 2
Setting for Barcode Reader ....................................... 3
Reading Barcodes ...................................................... 4
Troubleshooting .......................................................... 5
Cleaning the Reading Window .................................. 5
Symbols ........................................................................ 6
Various Barcode Settings .......................................... 6
Specifications ............................................ Back cover
This Supplementary Instructions explains how to get started with a barcode reader and point
out cases where the operation of the computer will differ from that in the Operating Instruc-
tions.
CF-U12DBarcodeReader.p65 2008/08/20, 18:06Page 1 AdobePageMaker6.5J/Win

2
Do not look directly into the reading window.
DO NOT LOOK DIRECTLYATTHE LED LIGHT.
Be sure to read “Precautions” in the Personal Computer Operating Instructions.
Reading Window
Trigger Buttons
When the computer is moved from hot and humid environment to low temperature
environment, dew condensation may mist up inside the lens. This is not a malfunction.
Dry the lens before use.
NOTE
Precautions
Names and Functions of Parts
CF-U12DBarcodeReader.p65 2008/08/20, 18:06Page 2 AdobePageMaker6.5J/Win

3
ENGLISH
The following menu opens by clicking icon on the notification area.
Connection to Barcode
(Power Saving Mode)
Connection to Barcode
(Always-On)
Disconnect Barcode Module
Confirmation Message On
Allow Code 39
Packet Mode
Exit 2D Barcode Key Emulator
To reduce the power consumption, stop barcode reader
connection within 1 minute after reading a barcode.
Keep barcode reader active even after reading a barcode.
Stop barcode reader connection in Always-On mode or
Power Saving Mode.
If the trigger button is pressed in Power Saving Mode, “Push
Barcode Trigger again to enable Barcode.” message is dis-
played to prevent operational errors.*1
Allow Code 39 type barcode. You can change the setting
by scanning Enable/Disable of Code39 ( Page 7).
Receive barcode decode data in packet mode.
Exit barcode reader operation.
When the computer enters Sleep (Model with Windows Vista)/Standby (Model with
Windows XP) or Hibernation in Power Saving Mode or Always-On mode, the Barcode
Reader is disabled. [Barcode Module was disconnected by changing the power status]
message appears at the next resume timing.
•In Power Saving Mode, click [OK] to reconnect with the Barcode Module.
•In Always-On mode, click [OK] and select [Connection to Barcode (Always-On)] again
from the above menu to reconnect with the Barcode Module.
When the computer is shut down in Power Saving Mode or Always-On mode, the
Barcode Reader is disabled.
•In Power Saving Mode, just turn on the computer to reconnect with the Barcode
Module.
•In Always-On mode, the Barcode Module is not reconnected only by turning on the
computer. Select [Connection to Barcode (Always-On)] again from the above menu.
The icon may not appear when you start up the computer for the first time. In this
case, restart the computer.
NOTE
*1 The confirm message is closed in the following cases.
•When five seconds pass from the display message.
•When the [Close] in the message window is clicked.
•When the trigger button is pushed again.
Setting for Barcode Reader
CF-U12DBarcodeReader.p65 2008/08/20, 18:06Page 3 AdobePageMaker6.5J/Win

4
1 Aim the reader at the barcode.
2 Press one of the trigger buttons on the rear side
of the computer.
The LED lights red to indicate the reading position.
To Correctly Read a Barcode with This Computer, Observe the Following.
The reading angle is important factor. Perform reading at the angle indicated in the figure.
We recommend you to set at approximately 2° to 3° angle from the perpendicular position.
Hold the reader farther away when reading a larger barcode, and closer in when reading a
smaller barcode or a thinner barcode.
Press trigger button.
(Page 2)
2° to 3°
Recommend
Reading Barcodes
Perform reading so that the entire symbol falls within the center of the red LED light.
Right
Right
LED light
CF-U12DBarcodeReader.p65 2008/08/20, 18:06Page 4 AdobePageMaker6.5J/Win

5
ENGLISH
Reading is not possible. Confirm that the barcode is readable (without damage,
etc.).
Confirm the range for reading.
Be sure the reader is programmed to read the type of
barcode you are reading.
The distance from the reader to the barcode is impor-
tant. As a rule of thumb, a farther distance should be
used for a larger symbol to allow the raster pattern to
cover the symbol. In addition, a closer distance should
be used for a thinner symbol.
Return the Barcode reader to the default setting.
If the reading window is dirty, gently wipe the reading window with a cloth or a cotton swab
moistened with water.
Do not allow materials that can easily scratch the reading window to touch the window, such
as sandpaper or metal object. In addition, do not directly apply a liquid such as water, deter-
gent, or alcohol, on the surface of the window.
For parts other than the reading window, please read “Maintenance” in the Personal Com-
puter Operating Instructions.
Troubleshooting
Cleaning the Reading Window
The reader can still read a barcode even if the barcode is not in the center of the red LED
light. However, if a part of the barcode lies slightly outside the LED light, the barcode
cannot be read. Make sure the entire barcode is inside the LED light.
Right Wrong
LED light
CF-U12DBarcodeReader.p65 2008/08/20, 18:06Page 5 AdobePageMaker6.5J/Win

6
Try reading the following barcodes to check your reader is working properly.
< UPC-A >
Scan the following barcodes to change the Barcode Reader settings.
Set factory preset
Code Type Enable Disable
RS-232 parameters-
RTS/CTS hardware
protocol
Australian Post
Aztec
Symbols
Various Barcode Settings
Panasonic
CF-U12DBarcodeReader.p65 2008/08/20, 18:06Page 6 AdobePageMaker6.5J/Win

7
ENGLISH
Code Type Enable Disable
BPO
Codabar
Codablock-
Codablock A
Codablock-
Codablock F
Code 11
Code 39
Code 93/Code 93i
Code 128/
EAN 128-Code 128
CF-U12DBarcodeReader.p65 2008/08/20, 18:06Page 7 AdobePageMaker6.5J/Win

8
Various Barcode Settings
Code Type Enable Disable
Code 128/
EAN 128-EAN 128
DataMatrix
Dutch Post
EAN.UCC Composite-
CC-A/B
EAN.UCC Composite-
CC-C
Interleaved 2 of 5
Japan Post
Matrix 2 of 5
CF-U12DBarcodeReader.p65 2008/08/20, 18:06Page 8 AdobePageMaker6.5J/Win

9
ENGLISH
Code Type Enable Disable
MaxiCode
MicroPDF417
MicroPDF417-
Code 128 emulation
MSI Code
PDF417
Planet
Plessey Code
Postnet
CF-U12DBarcodeReader.p65 2008/08/20, 18:06Page 9 AdobePageMaker6.5J/Win

10
Various Barcode Settings
Code Type Enable Disable
QR Code
RSS-RSS 14
RSS-Limited
RSS-Expanded
Standard 2 of 5
Telepen
TLC 39
UPC/EAN-UPC-A
CF-U12DBarcodeReader.p65 2008/08/20, 18:06Page 10 AdobePageMaker6.5J/Win