Panasonic DBS T1 User manual

Section 500
T1
Reference
Manual
Digital Business System
503X00501A
6/3/96

The contents of this manual are subject to change without notice and do not constitute a
commitment on the part of Panasonic Information and Communications Company (PICC). Every
effort has been made to ensure the accuracy of this document. However, due to ongoing product
improvements and revisions, Panasonic cannot guarantee the accuracy of printed material after
the date of publication nor can it accept responsibility for errors or omissions. Panasonic will
update and revise this document as needed.
The software and hardware described in this document may be used or copied only in accordance
with the terms of the license pertaining to said software or hardware.
Reproduction, publication, or duplication of this manual, or any part thereof, in any manner,
mechanically, electronically, or photographically, is prohibited without permission of the
Panasonic Information and Communications Company (PICC).
 Copyright 1996 by Panasonic Information and Communications Company
All rights reserved.
T-SMART and T-SERV II are registered trademarks of ADC Kentrox.
Premier is a registered trademark of U.S. Sprint.
Reference to third-party products is for information only and does not constitute an endorsement
or recommendation. Panasonic does not assume responsibility for the performance of third-party
products.

Issued 6/3/96 DBS-80-500 iii
Contents
About This Manual
Overview............................................................................................................................. ix
Related Documents............................................................................................................. ix
Chapter 1. Introduction to the T1 Interface
Overview................................................................................................................................. 1-3
Description of the T1........................................................................................................ 1-3
FramingOptions............................................................................................................... 1-3
TrunkSignalingModes.................................................................................................... 1-4
DNISService.................................................................................................................... 1-4
Pre-InstallationRequirements................................................................................................. 1-5
OrderingT1....................................................................................................................... 1-5
WhatYouMustPurchase................................................................................................. 1-6
Chapter 2. Installation
Guidelines............................................................................................................................... 2-3
HardwareRequirements................................................................................................... 2-3
Maximums........................................................................................................................ 2-3
Trunk Assignments for Single-Cabinet Systems .............................................................. 2-5
Trunk Assignments for Double-Cabinet Systems ............................................................ 2-6
Installation Procedures.......................................................................................................... 2-12
InstallingtheCSU........................................................................................................... 2-12
Installing a T1 in a Single Cabinet.................................................................................. 2-14
Installing T1 in a Double Cabinet with the T1 in the Slave ........................................... 2-21
Installing T1 in a Double Cabinet with T1s in the Master and Slave............................. 2-23
Chapter 3. Quick-Start Programming
BeforeYouBegin................................................................................................................... 3-3
Programming Initial T1 Options............................................................................................. 3-4
MinimumProgramming................................................................................................... 3-4
DNISProgramming.......................................................................................................... 3-7

iv DBS-80-500 Issued 6/3/96
Chapter 4. Programming Reference
T1SystemSettings................................................................................................................. 4-3
System Size....................................................................................................................... 4-3
Clock Settings................................................................................................................... 4-4
System-WideTimers.............................................................................................................. 4-7
DigitalPadSettings.............................................................................................................. 4-14
Extension Port Settings................................................................................................... 4-16
TrunkPortSettings......................................................................................................... 4-17
Master and Slave Settings..................................................................................................... 4-18
TrunkConfiguration....................................................................................................... 4-18
TrunkSignaling.............................................................................................................. 4-19
AlarmSettings...................................................................................................................... 4-21
Alarm Descriptions......................................................................................................... 4-21
Alarm Transmission Options.......................................................................................... 4-24
Alarm Timers ................................................................................................................. 4-25
ErrorCountersforFFAlarmKeys................................................................................. 4-29
AlarmRelayControls..................................................................................................... 4-32
Trunk Settings....................................................................................................................... 4-35
FFKeySettings.................................................................................................................... 4-42
Special T1 Function Codes................................................................................................... 4-43

Issued 6/3/96 DBS-80-500 v
List of Figures
Figure 2-1. CSU installation ..............................................................................................2-12
Figure 2-2. SCC-B Switch 4 ..............................................................................................2-14
Figure 2-3. Connector4 (CN4)strapping, SyncUnit ........................................................2-15
Figure 2-4. T1SyncUnitinstallation................................................................................ 2-16
Figure 2-5. T1MDFcardinstallation................................................................................2-17
Figure 2-6. Sync Unit and T1 connection, single-cabinet installation .............................. 2-18
Figure 2-7. RJ48pinouts,CN1connector......................................................................... 2-19
Figure 2-8. T1 cabinet connections, single-cabinet installation ........................................ 2-20
Figure 2-9. Sync cable connections, double-cabinet with a T1 in the slave ...................... 2-22
Figure 2-10. Clock sync cable and sync cable connections, double-cabinet installation ....2-24
Figure 4-1. Circuit-typenumbers ......................................................................................4-14
Figure 4-2. Defaultpadvalues ..........................................................................................4-15
Figure 4-3. Pad Nos. ..........................................................................................................4-15

vi DBS-80-500 Issued 6/3/96

Issued 6/3/96 DBS-80-500 vii
List of Tables
Table 1-1. Guidelinesfor orderingT1services ..................................................................1-5
Table 1-2. T1 Hardware requirements for single-cabinet systems..................................... 1-6
Table 1-3. T1 Hardware requirements for double-cabinet systems ................................... 1-6
Table 1-4. CSUequipmentrequiredforT1 .......................................................................1-7
Table 2-1. EC/TRKslotusageforT1................................................................................ 2-3
Table 2-2. T1 and analog trunk assignments, DBS 40 .......................................................2-5
Table 2-3. T1 and analog trunk assignments, DBS 72 .......................................................2-5
Table 2-4. T1 and analog trunk assignments, DBS 96 .......................................................2-6
Table 2-5. Maximum T1 assignments for two-cabinet systems ......................................... 2-6
Table 2-6. T1 and analog trunk assignments, DBS 40 + 40 ............................................. 2-7
Table 2-7. T1 and analog trunk assignments, DBS 72 + DBS 72 .................................... 2-8
Table 2-8. T1 and analog trunk assignments, DBS 96 + DBS 40 .................................... 2-9
Table 2-9. T1 and analog trunk assignments, DBS 96 + DBS 72 .................................. 2-10
Table 2-10. T1 and analog trunk assignments, DBS 96 + DBS 96 .................................. 2-11
Table 2-11. Switch settings for SW1 on the T1 card ......................................................... 2-18
Table 4-1. T1 alarm definitions ........................................................................................4-21
Table 4-2. Alarm-related programs ..................................................................................4-22

viii DBS-80-500 Issued 6/3/96

Issued 6/3/96 DBS-80-500 ix
About This Manual
Overview
This manual provides an overview of the DBS T1 Interface, along with
installation and programming instructions. The following table summarizes
each chapter contained in this manual.
Related Documents
For general instructions on DBS hardware installation, see Installation
(Section 300) . For an introduction to DBS programming, see Programming
Guidance (Section 400) .
Chapter Title Purpose
1Introduction to the
T1 Interface
Provides an overview of the DBS T1 Interface, plus informa-
tion on pre-installation requirements.
2Installation Provides step-by-step instructions on installing the DBS T1
hardware.
3 Quick-Start
Programming Summarizes the programs that are essential to T1 installation.
4 Programming
Reference Contains a complete list of T1 programming commands. Each
command description includes a list of the available options
and the associated programming addresses.

x DBS-80-500 Issued 6/3/96

Issued 6/3/96 DBS-80-500 1-1
Chapter 1. Introduction totheT1Interface
This chapter provides an overview of the T1 Interface. It also describes pre-
installation requirements for the T1.
The following table summarizes the topics contained in this chapter.
TopicPage
Overview 1-3
Description of the T11-3
Framing Options 1-3
Trunk Signaling Modes1-4
DNIS Service 1-4
Pre-Installation Requirements1-5
Ordering T1 1-5
What You Must Purchase1-6