Panasonic KX-TC1503B - 900 MHz Digital Cordless Phone User manual

ORDERNO. KM40106816C7
F11
TelephoneEquipment
KX-TC1503B / KX-TC1503W
900MHzDigital Cordless Answering System
Black Version
White Version
(for U.S.A.)
(for Panama)
SPECIFICATIONS
2001 Kyushu Matsushita ElectricCo., Ltd. All rights reserved.
Unauthorizedcopying and distribution isaviolation oflaw.

1. STANDARD BATTERY LIFE
BatteryCharge
Place the headseton the base unitand charge the batteryforabout 15 hours before initial use.
-TheINUSE/CHARGE/HOLDindicator lights.
Recharge
Whenthe RECHARGEindicatorflashes, orthe unitbeeps intermittently, recharge the batteryfor
about 15 hours.
-Ifyou DO NOTrechargethehandset batteryfor morethan15
minutes, theRECHARGE indicator will continuetoflash.

2. LOCATIONOF CONTROLS
2.1. Base unit

2.2. Handset
3. DISPLAY
3.1. Base UnitDisplay

4. CONNECTIONS

Note:
-USE ONLY WITHPanasonicACADAPTORKX-TCA1-G.
-TheACadaptor must remainconnectedat all times. (Itisnormal
for theadaptor tofeel warm during use.)
4.1. Adding AnotherPhone
This unitwill not function during a powerfailure. Toconnecta standardtelephone on the same

line, use the Panasonic T-adaptorKX-J66.
5. OPERATION
5.1. Making Calls

5.2. Answering Calls

5.3. AutomaticAnswering Operation
5.3.1. Setting theUnittoAnswer Calls

5.4. Listening toMessages

5.4.1. During playback

5.5. FLASHButton

6. DISASSEMBLY INSTRUCTIONS

ShowninFig.- ToRemove Remove
1LowerCabinet Screws (2.6 X12).....(A)X5
2MainP.C. Board Remove the P.C. Board
3Antenna Screw(2.6 X12).....(B)X1
Speaker Screws (3 X8).....(C)X3
4 BatteryCover Remove the BatteryCover
5 RearCabinet Screws (2.6 X12).....(D)X2
6 RearCabinet Remove the RearCabinet
7MainP.C. Board Screw(2.6 ×12).....(E)×1
Screws (2.6 ×10).....(F) ×2
Remove the lead
Remove the P.C. Board

7. TROUBLESHOOTINGGUIDE
Cross Reference:
Check Power ()
Error Message Table ()
Check Record ()
Check Playback ()
Check Battery Charge ()
Check Link ()
Check the RF Unit ()
Check Handset Transmission ()
Check Handset Reception ()
7.1. Check Power

Cross Reference:
Power Supply Circuit ()
Reset Circuit ()
NOTE:
FlashMemoryis IC300.
DSP is IC201.
7.2. Error MessageTable
NOTE:
FlashMemoryis IC300.
DSP is IC201.

7.3. Check Record
Cross Reference:
Telephone Line Interface ()
Auto Disconnect Circuit ()
Parallel Connection Detect Circuit ()
Signal Route ()
NOTE:
FlashMemoryis IC300.
DSP is IC201.
7.4. Check Playback