Panasonic KX-TGP600 User manual

Quick Start Guide
SIP Cordless Phone
SIP Cordless Handset
Model No. KX-TGP600
Model No. KX-TPA60
Français
SIP Wireless Desk Phone
Model No. KX-TPA65
DECT Repeater
Model No. KX-A406
English

KX-TGP600
i)

Hub
ii)
PNLV226xx/PQLV219LB
PQLV219xx

KX-TPA60
KX-A406
iii)

PQLV219xx
PNLV226xx/PQLV219LB
iv)

KX-TPA65
v)

vi)
PQLV219xx

Notes

Thank you for purchasing this Panasonic product.
Please read this Quick Start Guide carefully before using this
product and save this Quick Start Guide for future use.
These documentations are provided on the Panasonic Web site at:
For KX-TGP600/TPA60/TPA65
http://panasonic.net/pcc/support/sipphone/
(Including Open Source Software Notice)
For KX-A406
http://panasonic.net/pcc/support/pbx/
Describes information about the installation and operation of the
KX-TGP600/KX-TPA60/KX-TPA65.
Related Documentation
Operating Instructions
Administrator Guide
Installation Manual
Describes information about the programming and maintenance
of the KX-TGP600.
Describes information about the installation of the KX-A406.
Outline
This manual describes setup and safety information of the unit.
Note
In this manual, the suffix of each model number is omitted
unless necessary.
Quick Start Guide
SIP Cordless Phone
SIP Cordless Handset
Model No. KX-TGP600
Model No. KX-TPA60
SIP Wireless Desk Phone
DECT Repeater
Model No. KX-TPA65
Model No. KX-A406
English

Setup
Before setting up the equipment following the procedures below, refer to pages i)–
vi).
KX-TGP600
We recommend configuring these settings with your administrator. You can
configure the settings through the Web user interface by entering the IP address
of the KX-TGP600 in the Web browser. For details, consult your administrator.
KX-TPA60/KX-TPA65
Registering to a base unit
Up to 8 handsets can be registered.
1.Base unit of KX-TGP600:
Press and hold the handset locator button on the right side of the base unit
for about 4 seconds until the indicator flashes red.
RThe next step must be completed within 2 minutes.
2. KX-TPA60/KX-TPA65:
Press and hold about 3 seconds, then wait until a long beep sounds.
KX-A406
Registering to a cell station (Easy Registration)
1. Turn on the repeater by connecting the AC adaptor.
RIf the repeater is unregistered, the indicator will flash red, and the repeater
automatically enters Easy Registration mode.
RWhen the repeater has found a cell station, the indicator will turn green.
Registration is completed.
Note
RIn Manual Registration, the repeater can be registered to another repeater to
create a cascade configuration. For details, refer to the Installation Manual of
the repeater.
2
Setup