Panasonic MC-E871K User manual

Panasonic
We wouid particularly advise that you carefully study these Operating instructions before attempting to
operate the unit and that you note the Important Safety instructions.
This product complies with the European directives 73/23/EEC and 89/336/EEC and with the Australian
Standards AS 3350 2.2 (1995) and Australian EMC requirements for the C-Tick Mark.

! TABLE OF CONTENTS
• Caution for AC Mains Lead (UK, IRL only)
• Important safety instructions for the user
• Cautions.
• Identification of main parts.
A) How to assemble your cleaner.
B) How to operate your cleaner.
C) How to store your cleaner.
D) Maintenance and Servicing.
E) Accessory (Optional).
Page 2
3
3
4
5
5-7
7
7-8
8
REMINDER FOR CUSTOMER
I The mode! and serial number of this product may
| be found on the nameplate located at the bottom
I of your cleaner. You should note the model and
serial number in the spaces provided and retain
this book for future reference.
-—------
A CAUTION FOR AC MAINS LEAD (UK, IRL Only)
— : -i--
----
Model Number:.
Serial Number:.
! .
i Date Purchased:.
Where Purchased:..
FOR YOUR SAFETY PLEASE READ THE FOLLOWING TEXT CAREFULLY
This appliance is supplied with a moulded three pin mains plug for your safety and convenience.
A 13 amp fuse is fitted in this plug.
Should the fuse need to be replaced please ensure that the replacement fuse has a rating of 13 amps and
that it is approved by ASTA or BSI to BS1362.
Check for the ASTA mark <$> or the BSI mark ^ on the body of the fuse.
If the plug contains a removable fuse cover you must ensure that it is refitted when the fuse is replaced.
If you lose the fuse cover the plug must not be used until a replacement cover is obtained.
A replacement fuse cover can be purchased from your local Panasonic Dealer.
IF THE FITTED MOULDED PLUG IS UNSUITABLE FOR THE SOCKET OUTLET IN YOUR HOME THEN
THE FUSE SHOULD BE REMOVED AND THE PLUG CUT OFF AND DISPOSED OF SAFELY.
THERE IS A DANGER OF SEVERE ELECTRICAL SHOCK IF THE CUT OFF PLUG IS INSERTED INTO ANY
13 AMP SOCKET.
If a new plug is to be fitted please observe the wiring code as shown below.
If in any doubt please consult a qualified electrician.
IMPORTANT: The wires in this mains lead are coloured in accordance with the following code:
Blue: Neutral
Brown : Live
As the colours of the wire in the mains lead of this appliance may not correspond with the coloured
markings identifying the terminals in your plug, proceed as follows:
The wire which is coloured BLUE must be connected to the terminal in the plug which is marked with the
letter N or coloured BLACK.
The wire which is coloured BROWN must be connected to the terminal in the plug which is marked with
the letter L or coloured RED.
Under no circumstances should either of these wires be connected to the earth terminal of the three pin
plug, marked with the letter E or the Earth Symbol ±
How to replace the Fuse:
• There are two types of the supplied AC Mains Lead A and B as shown below.
1 Open the fuse compartment with a screwdriver.
2 Replace the fuse and fuse cover if detachable.
i
j
I
2

IMPORTANT SAFETY INSTRUCTIONS FOR THE USER
When using this vacuum cleaner, please observe these basic precautions.
WARNING: To reduce the risk of fire, electric shock, or injury:
» Do not leave the vacuum cleaner plugged in to mains outlet. Unplug from the outlet when not in use
and before cleaning the appliance or undertaken maintenance operations.
• Electric shocks can occur if used outdoors or on wet surfaces.
• This appliance is not intended for use by young children or infirm persons without supervision; young
children should be supervised to ensure that they do not play with the appliance.
• Do not use with damaged cord or plug. If the vacuum cleaner is not working as it should be, or has been
dropped, damaged, left outdoors, or come, into contact with water, consult an authorised Panasonic
Service Centre.
• Do not pull or carry by cord, ‘use cord as a handle, close a door on cord, pull cord around sharp edges
or corners. Do not run vacuum cleaner over the cord. Keep cord away from heated surfaces.
• Do not handle plug or vacuum cleaner with wet hands.
• Do not put any object into openings. Do not use with any opening blocked; keep free of dust, lint, hair
and anything that may block or reduce air flow.
• Turn off all controls before unplugging.
® Do not use the vacuum cleaner without filters and/or dust bag in place. Never try to patch a broken dust
bag.
• Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts.
• Do not use to pick up flammable or combustible liquids such as gasoline or use in areas where they
may be present.
®This appliance should be serviced by an authorised Panasonic Service Centre, and only genuine
Panasonic spare parts should be used.
• Use extra care when cleaning stairs. Keep hold of the handle to avoid the cleaner fall.
NOTE: These vacuum cleaners have been designed for general household use and are not suitable
for use in a garage, garden or to suck up liquids.
This appliance is provided with a flexible cord and if this becomes damaged, it must be repaired
by Panasonic, or an Authorised Service Centre or a qualified person in order to avoid any
hazard.

IDENTIFICATION OF MAIN PARTS
NOTE: When unpacking the vacuum cleaner, make sure that the accessories in the illustration
marked {*), are supplied with the product.
B-8) Manual suction control (*)
-______- A) Hose
Ref. no. AMC8A92P1000
NOTE: Floor nozzles and extension tubes are subject to change without notice.
4

B-2) Automatic cord rewind B-3) ON/OFF Switch
Rewind the cord, pressing the
pedal.
Start or stop the cleaner, pressing
the pedal.
Hard ftoor
Regularly clean the vacuum cleaner head
B-5) Floor nozzle dust sensor (depending on model)
The dust sensor indicator automatically informs you of the
cleaning conditions.
When dust is present in the air being vacuumed the red indicator
lights and remains lit until the air being vacuumed is free of dust,
the light then changes to green indicating that the area is clean.
The dust sensor may not operate correctly’if the air flow is
restricted due to a blockage or dust build-up on the sensor.
« Check the suction inlet, tube and hose for any blockage and
remove the obstruction.
» If the sensor is very dusty, dean it using a soft dry duster (Fig 1).
v-L/
Red light:
Dust is present
Green: Clean
NOTE: The RED indicator will light when the vacuum cleaner is first switched ON.

6

B-10} Dust bag check indicator
The dust bag check indicator is a visual aid to
advise you of the condition of the dust bag. A
red mark will appear in the window when
airflow through the bag is insufficient. When
this happens, check the paper bag, it may be
full or blocked with fine dust and needs to be
replaced, (see paragraph D-1).
NOTE: If after having replaced the bag, the
red mark continues to appear in the window,
check to see if the hose, tube or suction inlet is
blocked.
v ■
C\ HOW TO S Tore your cle =ANER
'
For easy storage and transporting, the vacuum cleaner includes a
clip system built onto the body of the cieaner, which will keep the
extension tube, hose and nozzle in a vertical position.
D) Maintenance and servicing
A IMPORTANT NOTE: Before servicing any part, always DISCONNECT the cleaner from
the electricity supply. the electricity supply.
D-1) How to replace the dust bag
1) R elease the hook as shown by the arrow and
lift the cover up.
Note: When lifting the cover up, keep your
hand away from the rear side of the cover to
avoid injury.
2) G rip the cardboard of the dust bag and pull it out.
3) I n stall the new dust bag placing the cardboard
into the guides of the dust bag support.
Before closing the cover, make sure all edges
of the dust bag are inside the bag
compartment.
4) C lose the dust cover.
IMPORTANT: When the dust bag is not in position or
it has not been installed correctly, the dust cover will
not close.
We recommend the use of genuine Panasonic bags Type C-2E only.

D-2) Filter care
Central Filter (Fig. 1) Part no. AMC8F03D11G0
The central filter (foam filter), is installed in the dust bag compartment
to protect the motor from dirt.
When it becomes dirty, simply rinse it out in warm water and dry it
thoroughly before replacing.
To remove the centra! filter, hold the filter at the top (as illustrated)
and pull it out.
Important: Ensure that the filter is completely dry before re-installing
it into the cleaner.
Clean Air Filter S-Class (Fig. 2) Type F-3s
The clean air filter is installed in the rear side of the cleaner. This filter
retains any small dust particles which may be present in the expelled
air.
it is advisable to change the clean air filter when it becomes dirty. As
a guide, once or twice a year is usually sufficient depending on use.
To change the clean air filter, hold the exhaust cover (as illustrated) and
pul! it out.
IMPORTANT: Never use the cleaner without the correct
filters properly installed. Failure to do so may result in
damage to the motor.
Ift^
E-1) Re-usable cloth bag
Part no. AMC8F9931300
230-24QV~5QHz
1400W
1200W
7.5 kg
MC-E873K/MC-E873
230-240V~50Hz
1500W
1300W
313x460x243
7.5 kg
SPECIFICATIONS j MC-E871K/MC-E871 MC-E873K/MC
Power source
Max. output
Nominal output
Dimensions (WxLxH) mm ! 313x460x243
Net weight
Dusting brush
Upholstery nozzle
Crevice nozzle
Extension tube (2/pcs)
Telescopic tube
Floor nozzle with dust sensor
Floor nozzle
Design and specifications may be changed without notice.
Weight and dimensions shown are approximate.
Matsushita Electric Espana, S.A.
DIVISION DE ASPIRADORAS
Zona Industrial del Pollgono de CELRA
17460 CELRA (Girona) SPAIN
Z07P10900
MC-E875K/MC-E875
230-240V~50Hz
1500W
1300W
313x460x243
7.5 kg
100% recycled paper A
Printed in Spain
a