Pandora DMS-100BT User manual

Door Sensor
DMS-1OOBT
Wireless door sensor DMS-100BT is designed for the remote detection of shock
and rotation, temperature, opening of the door that is located at a considerable
distance from the base unit of car service-security system.
The following zones can be controlled with this sensor: sunroof, coer cover, trunk,
trailer, case cover for carrying some valuables and so on.
Sensor’s operation is based on using of 3-coordinate accelerometer that allows
detecting rotations, shocks and door motions, and on using a magnetic pair (hall
sensor) for reliable detection of door opening/closing.
Installation
Open cover 1 of the base unit,
remove the battery 2 and
then attach cover 7 of the
base unit with screws 3 to the
door’s movable part.
Attach magnetic unit 6
with screws 5 to the door’s
xed part in a way to match
magnetic unit 6 with the
sensor’s base unit, magnetic
sensor 4 (see picture) when
closing door.
Gap must not exceed 5 mm
similar to the standard reed
sensor.
1
2
3
4
5
6
7

Programming sensor
1. Remove the sensor’s battery.
2. Enter programming level 23-24 on a security system; LED indicator will be lit
green.
3. Insert the battery into the sensor. Successful programming of the sensor to the
Firmware update of the sensor
Firmware update is performed on the 25-26 programming level of a security
system.
Replacing the battery
Open cover 1 of the base unit, remove battery 2 and insert the new one, respecting
the polarity.
Compatibility
Pandora Light Pro, Pandora Smart Pro, Pandora Mini
Battery 123А
Radio interface 2,4 GHz Bluetooth
Power consumption in active mode up to 30uA
Operating time from the battery up to 12 months
Manufacturer reserves the right to change set and construction of the product to improve its
pandorainfo.com
Product is in conformity with Electromagnetic Compatibility
Directive EMC 2004/108/EC and R&TTE Directive 1999/5/EC