Panorama Antennas CM-36-55 Series User manual

Installation Instruction – SW3-839
CM[X]-36-55-[VAR] Series
Introduction
A.
The CM[X]-36-55 range has been designed to provide MiMo dual
band 5G / Private LTE coverage in an ultra low profi le package.
The compact, robust low-profi le housing contains up to four
antenna elements with effective isolation and low correlation
covering 3.4-3.8/4.9-6GHz.
The antenna is designed to be ceiling or panel mounted and can
be fi tted on a conductive or non-conductive panel. Supplied with
integral fl ame retardant CS32 cables (Compliant to UN ECE 118
and EN45545-2) and a halogen free fl ame retardant radome, the
antenna is suitable for many environments.
SW3-839 - Document Version 1.0
Select a suitable mounting location:
B.
The antenna is omni-directional and should be mounted as centrally as possible within the desired
coverage area. The roof space should be accessible at this location to permit routing of cables to the
wireless device.
Select a fl at level location on the desired ceiling which is free from obstructions and not close to other
ceiling mounted items. Consider downward projection of antenna and any height clearance issues
with low ceilings.
Mount the Antenna
C.
If the ceiling is constructed with removable ceiling tiles, it may be best to
remove the tile, mount the antenna, and then re-fi t.
Mark the centre position of the antenna location and make a 19mm (3/4”)
hole.
Remove the adhesive pad backing and place the antenna in position.
Fit washer and nut - tighten to 4Nm.
Hole
∅19
Safety Note
Take care to avoid mounting the antenna in close proximity to metal ceiling furniture such
as girders, joists and air conditioning units as these objects may affect the antenna’s
performance.
Routing and terminating coaxial cable(s)
D.
Route the coaxial cables to the wireless device, taking care to avoid running adjacent to existing wiring or ceil-
ing furniture. The cables are pre-terminated with SMA plugs. If this type is unsuitable, use an adapter or fi t the
correct type.

Commission and test
E.
Using a suitable antenna analyser, carry out a VSWR test in each freq. band.
The VSWR should comply with values shown in the data sheet.
Connect the antenna to the coaxial cable and carry out a system check.
European Waste Electronic Equipment Directive 2002/96/EC
Please ensure that your old Waste Electricals and Electronics are recycled. Do not throw them
away into standard waste.
RF Safety Note
This antenna should be mounted in such a way that no person is within 20cm (8”) of the
antenna during use.
Notices
F.
Directive 2011/65/EU (RoHS 2)
This product is fully compliant with the RoHS 2 directive. Exemption 6.c applies
Waiver: This document represents information compiled to the best of our present knowledge. It is not intended to as a representation or warranty of fi tness
of the products described for any particular purpose. This document details guidelines for general information purposes only. Always seek specialist advice
when planning installations and ensure that antennas are always installed by a properly qualifi ed installer in compliance with local laws and regulations.