Panorama Antennas SW3-784 User manual

Installation Instruction - SW3-784
Introduction
A.
This instruc on covers low profi le antennas with M18 thread size moun ng bolt. The antenna is low profi le and doesn’t require a groundplane. The
L[G]-7-38 range can be fi  ed on metal or plas c panels. The L[G]P-7-38 range can be fi  ed on plas c / non-conduc ve panels or metal panels although
moun ng on a metal panel will result in some detriment to performance. The antenna will fi t panels of up to 9mm (0.35”) thickness.
Select A Suitable Mounting Location
B.
Select suitable moun ng loca on which is spaced away from other structures on the moun ng panel. The appropriate distance will depend on height of
structure, but minimum recommended spacing is one wavelength at the lowest opera ng frequency for the antenna. To calculate this, see below:
300 / frequency in MHz = Wave length (m) As an example for 900MHz - 300/900 = 0.33m (1’).
Ensure adequate under panel clearance and check for double skin or posi on of any cross brace. Measure to check for central posi on if applicable.
C.
Mount the Antenna
Mask the panel area around the hole posi on to protect the paintwork and
headliner (if applicable). Drill a pilot hole, then increase to 18mm (3/4”)
clearance, ensuring that the drill/cu er bit does not contact anything under
the panel. Clean area around the hole, carefully removing all swarf. Apply
some petroleum jelly or paint around the hole to prevent corrosion.
D.
Remove the protec ve backing from the underside of the antenna, feed the coaxial cable through the panel. Posi on the antenna over the hole
ensuring correct orienta on if applicable and s ck to panel by applying fi rm downward pressure. For op mal adhesion the antenna should be only
be installed at temperatures above 16°C (60°F). Assemble the nut and washer from underside and  ghten.
Fitting the Antenna
F. Important Notices
E. Routing and Terminating Coaxial Cable(s)
Route the coaxial cable to the equipment, taking care to avoid running adjacent to exis ng wiring or fouling any moving component. The cable(s) must
not be routed in front of any airbag device.
Prepare and Make A Hole
European Waste Electronic Equipment Direc ve 2002/96/EC
Waste electrical products should not be disposed of with household waste. All electronic products with the WEEE logo
must be collected and sent to approved operators for safe disposal or recycling. Please recycle where facili es exist. Many
electrical/electronic equipment retailers facilitate “Distributor Take-Back scheme”for household WEEE. Check with your Local
Authority or electronic retailers for designated collec on facili es where WEEE can be disposed of for free.
DO NOT
• operate the transmi er when someone is within 20cm (8”) of the antenna.
• operate the equipment in an explosive atmosphere.
• a empt to install the antennas without the proper safe equipment to access the install loca on.
• install the antenna near overhead power lines
• chew parts or put them in mouth, keep away from unsupervised children.
Direc ve 2011/65/EU (RoHS 2)
RoHS 2 compliance is declared per Direc ve 2011/65/EU and its subsequent amendments with exemp on 6.c applied.
REACH (Registra on, Evalua on, Authorisa on and Restric on of Chemicals, EC 1907/2006)
This product contains Lead (CAS No. 7439-92-1) which is classifi ed as an SVHC (Substance of Very High Concern) as being
toxic to reproduc on under Ar cle 57c. of REACH. Do not chew parts or put them in mouth, keep away from unsupervised
children. Dispose of parts as WEEE waste do not send to landfi ll.
Waiver: This document represents information compiled to the best of our present knowledge. It is not intended as a representation or warranty of fi tness of the products described for
any particular purpose. This document details guidelines for general information purposes only. Always seek specialist advice when planning installations and ensure that antennas are
always installed by a properly qualifi ed installer in compliance with local laws and regulations..
Version: 2.1

Installation Instruction - SW3-784
Waiver: This document represents information compiled to the best of our present knowledge. It is not intended as a representation or warranty of fi tness of the products described for
any particular purpose. This document details guidelines for general information purposes only. Always seek specialist advice when planning installations and ensure that antennas are
always installed by a properly qualifi ed installer in compliance with local laws and regulations..
EU Declara on of Conformity (RED)
Object Reference: LGX
Object Descrip on: Low Profi le Antenna with ac ve GNSS Antenna
Manufacturer: Panorama Antennas Ltd 61 Frogmore, London, SW18 1HF, U.K.
This declara on is issued under the sole responsibility of the manufacturer
The object of the declara on described above is in conformity with the relevant Union Harmoniza on Legisla on below:
Direc ve 2014/53/EU Radio Equipment Direc ve (RED)
Harmonised Standards and References:
EN 301 489-1 (V2.1.1): “Electromagne c compa bility and Radio spectrum Ma ers (ERM); Electro Magne c Compa bility
(EMC) standard for radio equipment and services; Part 1: Common technical requirements”.
Referencing EN 61000-4-2:2009 – Electrosta c Discharge Immunity and EN 61000-4-3:2006 +A1:2008 +A2:2010 – Radiated RF
Immunity
EN 300 440-1 V1.6.1 (2010-08) – Electromagne c compa bility and radio spectrum ma ers (ERM); short range devices; radio
equipment to be used in the 1GHz to 40GHz frequency range; Part 1: Technical characteris cs and Test methods in accordance
with EN 300 440-2 V1.4.1 (2010-8) - Electromagne c compa bility and radio spectrum ma ers (ERM); short range devices;
radio equipment to be used in the 1GHz to 40GHz frequency range
Low Voltage Direc ve: Direc ve 2014/35/EU (Electrical Equipment designed for use within certain voltage limits) of 26th
February 2014.
EN60950-1: Safety of informa on technology equipment – according to test specifi ca on EN 60950-1:2006+A2:2013
G. Additional Compliance Notice For LG Variants