Paradyne FrameSaver 9120 Owner's manual

TM
1
9000-A2-GK42-00 May 1998
FrameSaver1-Slot Unit
Installation Instructions Supplement
Document Number 9000-A2-GK42-00
May 1998
Introduction
The FrameSaver9120 unit that you have received has been produced
especially for applications such as yours, where the Frame Relay network
access is via the T1 Network (NET) interface, the same as in North America.
However, your unit requires the Universal power supply, rather than the
power supply used in North America. Therefore, the connection and operation
procedures listed in the
1-Slot Assembled Access Unit Installation Instructions
(Document No. 9000-A2-GN10) are accurate for your application, but the power
supply shown is different.
Safety Instructions
Please read the EMI warning and Important Safety Instructions that come with
this unit, in the
Universal Power Supply (220 Vac) Safety and Regulatory,
Warranty and Service Information
(Document No. 9000-A2-GX43).
Power Cords
Refer to the following table to verify that you have the appropriate power cord for
the wall-plug standard in your country.
Country Plug Standard Part Number Power Cord Description
Japan JIS 8303 125-0092-0031 IEC 320-to-JIS 8303 – 2.5m
Korea NEMA 5-15P 125-0007-0031 IEC 320-to-NEMA 5-15P – 2.3m
Installing the Universal Power Supply
Refer to Universal Power Supply Installation Instructions (Document
No. 9000-A2-GN21).

2 9000-A2-GK42-00
May 1998
Attaching Ferrite Chokes
Three ferrite chokes are shipped with your FrameSaver 9120 unit. You must
attach these ferrite chokes to the COM port and DTE cables as close to the unit
as possible (see figure below).
98-15994
POWER
PORT 1 PORT 2
COM NET DBM
DTE
Cable
DTE
Cable
V.35
Adapter
Cable
Frame
Relay
DTE
Frame
Relay
Router
or
FRAD
DSX-1
(FrameSaver 9120
Shown)
Ferrite Chokes

*9000–A2–GK42–00*
Copyright E1998 Paradyne Corporation