Paradyne Hotwire 5446 Operation and maintenance manual

TM
1
8000-A2-GK41-00 August 1997
HotWire Digital Subscriber Line Access Multiplexer (DSLAM)
Special Notice
Document Number 8000-A2-GK41-00
August 1997
Paradyne’s IP Injection Tool
The IP Injection Tool is an alternative to SNMP NMS to update the 5446 RTU’s
routing table. The IP Injection Tool uses the SNMP agent in the 5446 RTU to
manage IP address and subnet mask information.
This tool is available from Paradyne’s Power Pages World Wide Web site and
can be used with Windows ’95 or Windows NT 4.0. The program is in a zip file
that expands to three disks.
Installing the IP Injection Tool
This tool should be installed on a PC that is connected to the same LAN as the
DSLAM MCC (Management Communications Controller).
Procedure
To download the IP Injection Tool:
1. Access the Paradyne World Wide Web site:
http://www.paradyne.com
2. Click on:
Service & SupportMIBsHotWire DSLIP Injection Tool
3. Follow the steps for your program to unzip the IP Injection Tool. If you have:
— WinZip: Extract the files
— PKunzip: Unzip using the -d option to create three disks
4. Double-click on Disk 1 and double-click on Setup.exe.
5. At the prompt: Do you wish to install Microsoft OLE Automation?
— Windows ’95 platform: answer Yes
— Windows NT 4.0 platform: answer No
When the program is successfully installed, an icon labeled IP Injection Tool is
created. Utilize the online Help file for further information.

2 8000-A2-GK41-00
August 1997
Planning IP Addressing
Specific rules apply to IP Addresses and Subnet Masks. For additional
information, refer to
5446 RTU MIB Descriptions , Appendix G, of the
HotWire Digital Subscriber Line Multiplexer (DSLAM) User’s Guide,
Document 8000-A2-GB20.

*8000–A2–GK41–00*