PCTEL VenU PCTHP-CBRS-4-NF User manual

INSTALLATION INSTRUCTIONS
VenU®
Omnidirectional Panel Antenna
3.3~4.2GHZ | 4X4 | 4DBI | CBRS Omni Antenna | 4 Ports | N Jack
PCTHP-CBRS-4-NF

Stud Mount (Typical Installation)
1. Determine antenna installation location. Ensure that the mounting
surface is as at as possible.
2. Cut/drill holes through mounting surface sized and positioned as
shown in the schematic.
3. Clean mounting surface and bottom of antenna.
4. Feed cables through hole and route to desired location.
5. Position antenna onto mounting surface. Mounting stud shall be
located in the hole.
6. On bottom side of mounting surface slide slotted nut around cables
and assemble to mounting stud.
7. Four additional mounting holes are provided in each corner for extra
support if required.
INSTALLATION INSTRUCTIONS
VenU®PCTHP-CBRS-4-NF

INSTALLATION INSTRUCTIONS
VenU®PCTHP-CBRS-4-NF
Section View of Mounting Surface
Hole
Slotted Nut
Cables
Connector
VenU® PCTHP-CBRS-4-NF
Mounting Surface
Mounting Stud

PCTEL, Inc.
T: [phone] | pctel.com | NASDAQ: PCTI
Need help?
For assistance with installation, please contact
T: [phone]
VenU®PCTHP-CBRS-4-NF
Specications subject to change without notice. PCTEL® and VenU® are trademarks or registered trademarks of PCTEL, Inc..
All other trademarks are the property of their respective owners. ©2020 PCTEL, Inc. All rights reserved. (May 2020)