Pebble Grey Grace 300.20.45 User manual

CMYK SINGLE HEX
c32 m25 y25 k85 90% black #363636
RGB
54 54 54
INSTALLATION GUIDE
Garce LED Cabinet 300.20.45/300.20.46
Please read these instructions carefully before installation.
IEE Bathroom Zones
IMPORTANT
To ensure correct function of the sensor this product
MUST be installed with a minimum distance of 150mm
between the infrared sensor and any adjacent
worktop, surface, obstruction or tile trim.
•When working at heights, please use a suitable platform to
work from.
•Please note: For new installations, check for any electrical cables
or pipe work (gas/water) in the vicinity of the intended mounting
point before proceeding with the installation.
•
•Wear suitable eye protection when drilling. Be careful when
using power tools near water.
GENERAL
•THIS PRODUCT CONFORMS TO UK SAFETY STANDARDS AND MUST BE
INSTALLED IN ACCORDANCE WITH CURRENT IEE WIRING REGULATIONS
AND BUILDING REGULATIONS (PART P).
•THIS PRODUCT MUST BE EARTHED, AND SHOULD NOT BE CONNECTED
TO AN UNEARTHED CIRCUIT.
•ENSURE THAT CONNECTIONS ARE TURNED OFF AT THE CONSUMER
UNIT OR FUSE BOARD BEFORE INSTALLING OR CARRYING OUT ANY
MAINTENANCE.
•THIS PRODUCT IS FOR INDOOR USE ONLY.
•THIS PRODUCT IS IP44 RATED AND CAN BE INSTALLED IN BATHROOM
ZONE 2 (AS DEFINED BY THE IEE WIRING REGULATIONS) AND BEYOND.
SEE BATHROOM DIAGRAM.
•THE PRODUCT IS SUITABLE FOR INSTALLATION IN ZONE 2 OR HIGHER.
•IF THIS PRODUCT FEATURES REPLACEABLE BULBS THEN REPLACE FAILED
BULBS IMMEDIATELY. ALLOW THE GLASS, LAMP AND FITTING TO COOL
BEFORE REPLACING.
HANDLE WITH CARE!
When unpacking never stand the unit on a hard
To avoid the risk of electrocution, please turn off
the electricity mains supply before commencing
installation.
Please do not hang or drape clothing or material
over the mirror. LEDs can get very hot and this may
Please do not place objects too close to the LEDs as
this will cause the object to burn or melt.
Do NOT strike mirror glass with hard or pointed items. It is
recommended that the product is cleaned with a soft, dry, non
abrasive cloth. Do NOT use cleaning agents or abrasive materials
contact with the electrical components. Keep your bathroom well
ventilated where possible.
COMPLIANCE
This product complies with the following safety standards:
BS EN 60598-1: 2008+A11: 2009, EN60598-2-1: 1989
WIRING
This product is designed and manufactured in the Class 1 category,
meaning a ground wire is required.
COLOUR CODING
LIVE Brown
NEUTRAL Blue
EARTH Green & Yellow
zone
2
radius
zone
2
zone
2
225cm
zone
1
60CM
60CM
60CM
MIN
150mm
Grace 300.20.45
700mm x 500mm
Grace 300.20.46
700mm x 815mm

CMYK SINGLE HEX
c32 m25 y25 k85 90% black #363636
RGB
54 54 54
INSTALLATION GUIDE
Installation Procedure
1. Open the carton and make sure all the parts listed below
are present.
NOTE:ADDITIONAL FIXINGS REQUIRED TO ALLOW INSTALLATION ON PLASTERBOARD WALLS
2. Mark a desired height of the cabinet. Drill the required
holes and install the brackets.
NOTE:
NOTE: Please fully ensure the hanging hooks is connecting with the brackets.
Wall plugs supplied are only suitable for solid stone/brick
walls. Please ensure the screws are fully tight.
3. electrical supply has been turned off. This cabinet is a class
1 product and requires an earth connection. It should be
installed in accordance with the latest IEE regulations.
1X
2X
Output Wires
DISTANCE AIS THE DISTANCE
BETWEEN THE HANGING HOOK
6. Insert the shelfs.
Hang the Cabinet onto the wall. Activate the lights via the
sensor switch.
4.
5.
Insert the internal securing screw and attach the screw cap.
6X
7X 2X
1X
8X
A
B
DISTANCE
B
IS THE DISTANCE
BETWEEN THE FIXING HOLES
Wall screws
Wall plugs

CMYK SINGLE HEX
c32 m25 y25 k85 90% black #363636
RGB
54 54 54
INSTALLATION GUIDE
DISPOSAL
Waste Electrical & Electronic Equipment Regulations (WEEE) requires that any
of our products showing this mark (left) must not be disposed of with other
household or commercial waste.
Pebble Grey Ltd does not levy any WEEE disposal charges to its customers
for affected WEEE related products.
To prevent possible harm to the environment or human health from
uncontrolled waste disposal, please separate any such product from other
waste types and recycle it responsibly at your local facilities. Check with your
Local Authority, Recycling Center or retailer for recycling advice.
GUARANTEE
This product has a free replacement parts guaranteed in the UK for a period of
1 year from the date of purchase. The guarantee is invalid in the case of
improper use, incorrect installation or tampering.
Should this product fail during the guarantee period, please contact our
support team by email at [email protected] and we will replace the
relevant component part free of charge.
Pebble Grey does not accept responsibility for any installation costs associated
with the replacement of the component parts. Your statutory rights are not
prior notice.
EXTENDED GUARANTEE
We offer an extended guarantee FREE OF CHARGE on selected products.
Activate online within 30 days of purchase to qualify.
For more information visit www.pebblegrey.co.uk/product-guarantee
100% RECYCLED CARTON
Our cardboard packaging is 100% recycled.
Please dispose of all waste responsibly.
Bluetooth operation
- When the mirror is turned offthe connection to the
Bluetoothwill be lost. When the mirror is turned on again it
will automatically reconnect to the last connected device.
- Refer to your device manual for operating controls.
- Music will stop playing when a phone call comes into the
Bluetooth
®
device, and will automcally reconnect when
finished.
Trouble Shooting Guide
Device
not paired
Device
not connecting
Symptoms Possible problem Solution
Bluetooth
®
not
activated Check Bluetooth is activated
on compatible device &
mirror is turned on
Only one device can
be connected to the
mirror at any one time
Disconnect all devices and
reconnect only one device
No volume
No connection
Volume is cont rolled
from device Increase volume on device
Out of range Range is within 8 meters
move device closer to mirror
®
2. Acctvate the Bluetooth
®
on your device.
1. To activate the Bluetooth , operate the sensor
switch located at the bottom of the cabinet.
The cabinet will give out a tone to confirm it is
ready for pairing.
®
Search and connect the Bluetooth ‘Pebble Grey’
After a tone to confirm the connection,
you can now listen to your favorite song or
line radio station via the stereo speakers.