peerless-AV DS-S555-4X2 User manual

12014-07-29 #:009-9090-6 (2020-01-14)
ENG
DS-S555-4X2
46" - 55"
(117 - 140 cm)
800 lb
(363 kg)
MAX

22014-07-29 #:009-9090-6 (2020-01-14)
ENG - This product is designed to be installed on solid concrete. Hardware is included for solid concrete
installation. Before installing make sure the supporting surface will support the combined load of the equipment
and hardware. Screws must be tightly secured. Do not overtighten screws or damage can occur and product
may fail. Never exceed the Maximum Load Capacity. Always use an assistant or mechanical lifting equipment to
safely lift and position equipment. This product is intended for indoor use only. Use of this product outdoors could
lead to product failure or personal injury. Be careful not to pinch ngers when operating the mount. For support
please call customer care at 1-800-865-2112.
WARNING
Symbols
ENG
WARNING
ENG
x3
Screws must get at
least three full turns
and t snug.
ENG
Do not overtighten screws.
ENG
Tools Needed for Assembly.
ENG
To properly tighten screws: Tighten until screw
head makes contact, then tighten another 1/2
turn. Do not overtighten screws.
1
2
+1/2
4
3
ENG
Display center.
ENG
3/8"
(10mm)
3/8"
(10mm)

32014-07-29 #:009-9090-6 (2020-01-14)
Parts (Before beginning, make sure you have all parts shown below).
Parts List
Part #
Description Qty
Apedestal 3 147-T1426
Bcolumn 3 146-T1131
Ccover 3 145-T1809
Dside support bracket 2 145-T1807
Evertical support bracket 4 145-T1806
Fleft adaptor bracket 8 146-1609
Gright adaptor bracket 8 146-1608
Hcomputer cover 1 145-T1930
Icomputer shelf 1 145-T1931
Jdual cross support 4 146-T1905
Kcord bracket 6 146-T1321
Lknob 6 560-1160
Mbracket, 4x2 conguration 2 145-T1858
NM8 x 16mm socket button screw 84 520-9527
OM8 square nut 36 530-1066
Pcover clip 12 590-0317
QM5 x 10mm type-f, socket pin screw 18 520-1164
R1/4" power bit 1 560-0263
S5mm allen wrench 1 560-9640
Tnylon shoulder washer 32 590-2233
UM6 x 12mm socket pin screw 32 520-1050
V4mm allen wrench 1 560-9646
WM6 x 35mm screw 12 520-0717
Xrawl bolt #6913 12 5M9-381-H03
C (3)
cover
B (3)
column
E (4)
vertical support
bracket
D (2)
side support
bracket
A (3)
pedestal G (8)
right adaptor
bracket
F (8)
left adaptor
bracket
ENG

42014-07-29 #:009-9090-6 (2020-01-14)
V (1)
4mm allen
wrench
H (1)
computer cover
N (84)
M8 x 16mm
O (36)
M8 square nut
P (12)
cover clip
Q (18)
M5 x 10mm
R (1)
1/4" power
bit
S (1)
5mm allen
wrench
T (32)
nylon shoulder
washer
U (32)
M6 x 12mm
I (1)
computer shelf
M (2)
bracket, 4x2
conguration
rawl bolt
X (12)
M6 x 35mm
W (12)
J (4)
dual cross
support
K (6)
cord
bracket
L (6)
knob

52014-07-29 #:009-9090-6 (2020-01-14)
W (4)
AB
1
x3

62014-07-29 #:009-9090-6 (2020-01-14)
2-1
2-2
DISPLAYHEIGHT
TIGHTEN
CONNECTING
HARDWARE
x2
1/8"
(3mm)
1/8"
(3mm)
x4 N (6)
O (4)
E (4)
E
S
S

72014-07-29 #:009-9090-6 (2020-01-14)
3-1
x2x2 P (4)
C
3-2
K (2)
L (2)
TOP VIEW
KL
TIGHTEN
CONNECTING
HARDWARE

82014-07-29 #:009-9090-6 (2020-01-14)
4
Use metric formula below and diagram to
right to determine hole pattern required for
center vertical support bracket. Repeat (x2).
All dimensions are metric.
Use the outside mounting holes when…
a x 4 > 4368mm and a x 3 + b < 4318mm
Use the inside mounting holes when…
a x 4 > 4098mm and a x 3 + b < 4064mm
N (12)
O (8)
M
O (8)
M
N (12)
BACK
SIDE
1/8"
(3mm)
b
a
BACK OF DISPLAY
x2 S
ENG
ENG ENG

92014-07-29 #:009-9090-6 (2020-01-14)
5
ENG - When installing Peerless mounts on a concrete oor, the oor must be at least 8" thick with a minimum
compressive strength of 2000 psi. Never attach concrete expansion anchors to concrete covered with plaster,
drywall, or other nishing material.
WARNING

10 2014-07-29 #:009-9090-6 (2020-01-14)
X (12)
45-1
Align base. Mark mounting holes.
ENG
5-3
Align base. Install using concrete anchors
provided.
ENG
3/8"
(10mm)
55.00"
(1397mm)
55.00"
(1397mm)
55.00"
(1397mm)
55.00"
(1397mm)
ENG Maximum 35 ft • lb (47 N.M.).
5-2
Drill mounting holes into
supporting surface
(3" (76mm) minimum
depth required).
ENG
3/8"
(10mm)
3"
(76mm)
3/8"
(10mm)