Pegasus TRINOVA User manual

TRINOVA™
Therapy Cushion
Quick Reference Guide - refer to User Guide for full instructions
Setting up the cushion
TRINOVA CUSHION
If the system is operating with the mattress connected, disconnect the mattress from the
power unit (see mattress guide).The mattress will stay fully inflated for 24hrs. Mute any
alarms using the reset button.
●Remove chair cushion and check chair base is in good condition and will support the
patient.
●Place theTRINOVA cushion on the chair base, pushed to the back of the chair, air hose
at FRONT of cushion.
●Connect air pipe to power unit by pushing in - DONOTTURN. (GREEN dots on
connectors will line up).
●Ensure the power unit is plugged in and switched on.
●The Cushion Connected (seated patient graphic) light will illuminate on the power unit.
●Wait until the cushion is fully inflated and operating (cycling) correctly before use
(approx 4 mins).
●The cushion may feel firm at first until it has adjusted to the individual.This will take
about 10 mins.
●Explain cushion operation to user,and ensure the user is comfortable and stable on the
cushion and chair.
QUICK REFERENCE GUIDE

Alarm/Faults
●ALARM: If at any time the mains power should be
removed from the power unit,an audible alarm will be
heard and all lights on power unit and mains switch
will go out.This audible alarm may be muted by
pressing the alarm reset button on the power unit.
●FAULTS: If the product develops a defect whilst in
use, the system alarm indicator light will illuminate and
an audible alarm will be heard. Refer to the Alarms
and Fault Finding section of the USERGUIDE for
further guidance and if necessary contact an
authorised engineer.
Pegasus Limited Pegasus House Waterberry Drive Waterlooville PO7 7XX Tel: [phone] Fax: [phone]
Email: [email protected] www.pegasus-uk.com
LFT15240
Issue 1.3