Insynctive®Product Guide | 10
LOCK SENSOR. NOTE: Once the plastic tab is removed
from the battery, you will have 2 minutes to pair your
LOCK SENSOR to BRIDGE. If 2 minutes pass without
successfully pairing, remove and insert the battery
again. You are ready to pair LOCK SENSOR to BRIDGE.
5. Pair LOCK SENSOR to BRIDGE. Each INTEGRATED
ENTRY DOOR SENSOR will need to be paired
to BRIDGE.
Manual pairing. Press and hold BRIDGE Pair button
until light begins flashing orange. The Pair button is the
bottom button located on the side of BRIDGE.
NOTE: BRIDGE is in pair
mode while the orange
light is flashing. BRIDGE
will remain in pair mode
for 2 minutes. BRIDGE
will then beep, and
orange light will turn off
to indicate BRIDGE exited
pair mode.
To pair LOCK SENSOR to
BRIDGE, ensure that your
entry door is closed and
locked; then unlock and
lock your door 2 times
within 10 seconds. Wait
for the light on BRIDGE
to flash green and beep
for 2 seconds. This will indicate a successful pair. If
LOCK SENSOR pair is unsuccessful, return to Step 4 and
retry the process. Repeat the previous steps until all
INTEGRATED ENTRY DOOR SENSORS have been paired
to BRIDGE. To exit pair mode, press and hold Pair button
on BRIDGE until light stops flashing orange.
6. Test INTEGRATED ENTRY DOOR SENSORS. Each
INTEGRATED ENTRY DOOR SENSOR should be tested
to ensure proper function after it is paired.
To test LOCK SENSOR, use the following procedure:
Unlock your entry door and verify that LOCK SENSOR
reports the product as unlocked on your compatible
home automation system. BRIDGE will beep twice.
To test OPEN/CLOSE SENSOR, use the following
procedure: Open your entry door and verify that OPEN/
CLOSE SENSOR reports the product as opened on your
compatible home automation system. BRIDGE will beep
twice. If any of these steps fail, see the troubleshooting
information on page 15.
NOTE: If you have selected the chimes to be off, BRIDGE
will not beep. See page 7 for information on setting up
chimes.
INTEGRATED SENSOR setup for entry door from Pella
with multipoint lock. See Pella.CustHelp.com for how-to
videos.
1. Get started.Ensure BRIDGE is set up. For BRIDGE setup
instructions, see page 6.
2. Prepare OPEN/CLOSE
SENSOR.
Use a small flathead
screwdriver to remove
the plastic endcap from
OPEN/CLOSE SENSOR.
Remove the plastic tab
from the battery, or
remove and reinsert the
battery if the tab is already
removed, then install the
plastic endcap back onto
OPEN/CLOSE SENSOR.
3. Pair OPEN/CLOSE
SENSOR to BRIDGE. Each
INTEGRATED ENTRY
DOOR SENSOR will need
to be paired to BRIDGE.
Manual pairing. Press and
hold BRIDGE Pair button
until light begins flashing orange. The Pair button is the
bottom button located on the side of BRIDGE.
NOTE: BRIDGE is in pair mode while the orange light is
flashing. BRIDGE will remain in pair mode for 2 minutes.
BRIDGE will then beep, and orange light will turn off to
indicate BRIDGE exited pair mode.
To pair OPEN/CLOSE SENSOR to BRIDGE, open then
close your entry door twice within 10 seconds. Wait
for the light on BRIDGE to flash green and beep for 2
seconds. This will indicate a successful pair. If OPEN/
CLOSE SENSOR pair is unsuccessful, return to step 2
and retry the process.
4. Prepare LOCK SENSOR. This lock transmitter is the
same sensor that is used in multiple INTEGRATED
SENSOR units. The lock transmitter must learn what type
of product it will be housed in. Follow the outlined steps
to prep the lock transmitter. Remove the lock transmitter
Integrated Entry Door Sensor (continued)
Battery
Open/Close
Sensor
Lock/Unlock
