4 5
NOTICES
1Reorient or relocate the receiving
antenna.
2Increase the separation between
the equipment and receiver.
3Connect the equipment to an
outlet on a circuit different from
that to which the receiver is
connected.
4Consult the dealer or an
experienced radio/TV technician
for help.
CAUTION:
1 To comply with FCC RF exposure
compliance requirements, a
separation distance of at least 20
cm must be maintained between
the antenna of this device and all
persons.
2This transmitter must not be
co-located or operating in
conjunction with any other
antenna or transmitter.
This device complies with part 15 of
the FCC Rules. Operation is subject
to the following two conditions: (1)
this device must not cause harmful
interference, and (2) this device must
not accept any interference received,
including interference that may cause
undesired operation.
NOTE: This equipment has been
tested and found to comply with the
limits for a Class B digital device,
pursuant to Part 15 of the FCC
Rules. These limits are designed to
provide reasonable protection against
harmful interference in a residential
installation. This equipment generates,
uses and can radiate radio frequency
energy and, if not installed and used
in accordance with the instructions,
may cause harmful interference to
radio communications. However, there
is no guarantee that interference will
not occur in a particular installation. If
this equipment does cause harmful
interference to radio or television
reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct
the interference by one or more of the
following measures:
Read and follow all warnings,
instructions, and procedures before
using the Peloton Tread. It is the
owner’s responsibility to ensure that
all users are aware of all warnings
and precautions. Use only as
described. Peloton is not responsible
for damage or injury caused by
inappropriate use.
Consult a physician before beginning a
new tness plan. Incorrect or excessive
training can result in serious injury.
If you experience faintness, chest pain,
or shortness of breath, stop exercising
immediately and consult a physician.
Keep children and animals away from
the Tread.
The Tread is designed for home use. Do
not use in a commercial or rental setting.
Inspect the Tread for loose, worn,
damaged, or incorrect parts before
using. Do not use before parts are
replaced, repaired, or tightened.
Do not wear loose or dangling clothing
while using the Tread. Keep towels and
loose clothing away from the slat belt.
Make sure your shoelaces don’t extend
past the soles of your shoes.
User weight must not exceed 300 lbs.
Be careful when mounting and
dismounting. Never mount or dismount
while the belt is moving. Use handrails
for support, but avoid resting your
whole weight on the handrails.
When the Tread is in Free Mode, the
belt moves freely. If you inadvertently
start the belt moving, you could fall.
Never leave the Tread unattended in
Free Mode.
If an error occurs during operation, the
Tread belt may come to a gradual or
sudden stop, depending on the error
and your speed. Always remain alert
while using the Tread.
Ensure that the power supply is
plugged into an outlet that supports 15
amps and complies with local building
codes.
Unplug the Tread and remove the
safety key before servicing and when
it is not in use. Always store the safety
key away from the Tread and out of
reach of children.
Familiarize yourself with emergency
stop procedures before using the Tread.
Do not use or store the Tread outdoors
or in damp or wet locations.
Always keep the running surface clean
and dry.
Set up and operate the Tread on a solid,
level surface. Make sure you have at
least 78.7" of clearance directly behind
the Tread, and 20" of clearance on
each side of the Tread.
Use only original parts from
Peloton. Unauthorized changes or
modifications to this equipment could
damage the Tread, impair its operation,
and void your warranty.
SAFETY INFORMATION
This product is ANT+™
certied and is compatible
with ANT+ sensors
that support heart rate
monitoring.
Do not attempt to service the Tread
yourself other than performing the
basic maintenance described in this
manual. Service other than basic
maintenance should be performed
by authorized personnel.
Keep hands away from moving parts.
Never touch the moving belt or reach
under the Tread while it is powered on.
Never operate the Tread if it isn’t
working properly, or if the power cord
has been damaged. Keep power cord
away from heated surfaces, sharp
edges, and water.
Do not soak or spray Tread surfaces
with liquid. Clean using a damp cloth.
Do not store items in the side
compartments while the Tread is
in use.
Metrics on the screen, including heart
rate monitoring, may be inaccurate.
Use values for reference only.
