Pentair AND 1060G Operating instructions

NOTE! To the installer: Please make sure you provide this manual to the owner of the equipment or to the responsible
party who maintains the system.
1060 AND 1060G SERIES
(Vertical and Horizontal Mount)
ASME PLAIN STEEL
EXPANSION TANKS FOR
HEATING & COOLING SYSTEMS
INSTRUCTION, INSTALLATION, MAINTENANCE AND REPAIR MANUAL
Part #A-03-328 | © 2012 Pentair Ltd. | 11/19/12

1060 & 1060G SERIES MODELS
2
SECTION 2ITEM 1060
DATED NOVEMBER 2012
SUPERCEDES MAY 2010
VESSEL DESCRIPTION:
Aurora Type 1060 & 1060G Series Tanks are ASME
constructed, plain steel, expansion tanks. They are designed
to absorb the expansion forces and control the pressure in
heating / cooling systems.
The system’s expanded water enters the tank and further
compresses the pressure controlling air cushion.
CONSTRUCTION DETAILS:
Materials of Construction
Shell Carbon Steel
Heads Carbon Steel
Maximum Operating Conditions
Working Temperature 450˚F (232˚C)
Working
Pressure
Models 1060 12x33 to 1060 16x72 150 psi (1034 kPa)
Models 1060 20x62 to 1060 42x96 125 psi (862 kPa)
STEPS & PROCEDURE:
• Visually inspect tank for damage, which may occur during
transit.
• Installsight-glasstrimasrequiredbydesignengineer.
• Set tank in place and pipe system connection to system. Be
sure to include isolation valve(s) and drain.
• Allowsystemwatertoenterandcompresstankaircushion.
Approximately one half (1⁄2) of the tank volume will be
displaced with system water to reach 15 psi.
• The following table is a guideline to achieve proper water
level:
System
Fill Pressure
(psi)
Water
Volume
(%)
Air
Volume
(%)
12 45 55
15 50 50
20 58 42
25 63 37
30 67 33
35 70 30
40 73 27
• Itisrecommendedthatthesight-glasswaterlevelbechecked
every six (6) months to ensure proper system protection and
vessel’s long life.
• Iftankbecomeswaterlogged,isolatetankanddrainoffstored
water. Then, reintroduce system water into the tank and
observe water level.
CALIFORNIA PROPOSITION 65 WARNING:
This product and related accessories
contain chemicals known to the State of California to cause
cancer, birth defects or other reproductive harm.

THIS PAGE INTENTIONALLY LEFT BLANK

WARRANTY
Seller warrants equipment (and its component parts) of its own manufacture against defects in materials and workmanship under normal use
and service for one (1) year from the date of installation or start-up, or for eighteen (18) months after the date of shipment, whichever occurs
first. Seller does not warrant accessories or components that are not manufactured by Seller; however, to the extent possible, Seller agrees to
assign to Buyer its rights under the original manufacturer's warranty, without recourse to Seller. Buyer must give Seller notice in writing of
any alleged defect covered by this warranty (together with all identifying details, including the serial number, the type of equipment, and the
date of purchase) within thirty (30) days of the discovery of such defect during the warranty period. No claim made more than 30 days after
the expiration of the warranty period shall be valid. Guarantees of performance and warranties are based on the use of original equipment
manufactured (OEM) replacement parts. Seller assumes no responsibility or liability if alterations, non-authorized design modifications
and/or non-OEM replacement parts are incorporated If requested by Seller, any equipment (or its component parts) must be promptly
returned to Seller prior to any attempted repair, or sent to an authorized service station designated by Seller, and Buyer shall prepay all
shipping expenses. Seller shall not be liable for any loss or damage to goods in transit, nor will any warranty claim be valid unless the
returned goods are received intact and undamaged as a result of shipment. Repaired or replaced material returned to customer will be
shipped F.O.B., Seller's factory. Seller will not give Buyer credit for parts or equipment returned to Seller, and will not accept delivery of
any such parts or equipment, unless Buyer has obtained Seller's approval in writing. The warranty extends to repaired or replaced parts of
Seller's manufacture for ninety (90) days or for the remainder of the original warranty period applicable to the equipment or parts being
repaired or replaced, whichever is greater. This warranty applies to the repaired or replaced part and is not extended to the product or any
other component of the product being repaired. Repair parts of its own manufacture sold after the original warranty period are warranted for
a period of one (1) year from shipment against defects in materials and workmanship under normal use and service. This warranty applies to
the replacement part only and is not extended to the product or any other component of the product being repaired. Seller may substitute
new equipment or improve part(s) of any equipment judged defective without further liability. All repairs or services performed by Seller,
which are not covered by this warranty, will be charged in accordance with Seller's standard prices then in effect.
THIS WARRANTY IS THE SOLE WARRANTY OF SELLER AND SELLER HEREBY EXPRESSLY DISCLAIMS AND BUYER
WAIVES ALL OTHER WARRANTIES EXPRESSED, IMPLIED IN LAW OR IMPLIED IN FACT, INCLUDING ANY WARRANTIES
OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. Seller's sole obligation under this warranty shall be, at its
option, to repair or replace any equipment (or its component parts) which has a defect covered by this warranty, or to refund the purchase
price of such equipment or part. Under the terms of this warranty, Seller shall not be liable for (a) consequential, collateral, special or
liquidated losses or damages; (b) equipment conditions caused by normal wear and tear, abnormal conditions of use, accident, neglect, or
misuse of said equipment; (c) the expense of, and loss or damage caused by, repairs or alterations made by anyone other than the Seller; (d)
damage caused by abrasive materials, chemicals, scale deposits, corrosion, lightning, improper voltage, mishandling, or other similar
conditions; (e) any loss, damage, or expense relating to or resulting from installation, removal or reinstallation of equipment; (f) any labor
costs or charges incurred in repairing or replacing defective equipment or parts, including the cost of reinstalling parts that are repaired or
replaced by Seller; (g) any expense of shipment of equipment or repaired or replacement parts; or (h) any other loss, damage or expense of
any nature.
The above warranty shall not apply to any equipment which may be separately covered by any alternate or special warranties.
PERFORMANCE: In the absence of Certified Pump Performance Tests, equipment performance is not warranted or guaranteed.
Performance curves and other information submitted to Buyer are approximate and no warranty or guarantee shall be deemed to arise as a
result of such submittal. All testing shall be done in accordance with Seller's standard policy under Hydraulic Institute procedures.
LIABILITY LIMITATIONS: Under no circumstances shall the Seller have any liability under the Order or otherwise for liquidated
damages or for collateral, consequential or special damages or for loss of profits, or for actual losses or for loss of production or progress of
construction, regardless of the cause of such damages or losses. In any event, Seller's aggregate total liability under the Order or otherwise
shall not exceed the contract price.
ACTS OF GOD: Seller shall in no event be liable for delays in delivery of the equipment or other failures to perform caused by fires, acts of
God, strikes, labor difficulties, acts of governmental or military authorities, delays in transportation or procuring materials, or causes of any
kind beyond Seller's control.
COMPLIANCE WITH LAW: Seller agrees to comply with all United States laws and regulations applicable to the manufacturing of the
subject equipment. Such compliance shall include: The Fair Labor Standards Acts of 1938, as amended; Equal Employment Opportunity
clauses of Executive Order 11246, as amended; Occupational Safety and Health Act of 1970 and the standards promulgated thereunder, if
applicable. Since compliance with the various Federal, State, and Local laws and regulations concerning occupational health and safety,
pollution or local codes are affected by the use, installation and operation of the equipment and other matters over which Seller has no
control, Seller assumes no responsibility for compliance with those laws and regulations, whether by way of indemnity, warranty, or
otherwise. It is incumbent upon the Buyer to specify equipment which complies with local codes and ordinances.
800 Airport Road
North Aurora, Illinois 60542
630-859-7000
www.aurorapump.com