Percussion Play Cherub User manual

Surface Fixed
Components:
1. Carefully lay 2 x legs on a
level surface and insert
M10x200 bar and nuts. Using
packing box as protection lay
instrument note side down on
the card. Line up pre drilled
holes in the backboard with
the legs and ensure the
instrument is aligned square
with the legs. Fix in place
using M10x100mm screws
supplied (see installation
guide)
2. Attach surface plates to
each leg with M10x70mm and
Barrel nuts supplied. ( See
Surface Fix Installation Sheet)
Installation Instructions
5. Beaters can be fixed to
Stainless Steel posts with
fixings provided
1100
Ground Surface
Pair Small
Beaters X1 22 Kg
BS EN 1176
1.5m
Weight of heaviest part 15kg
1.5m
Install Instrument
with 1.5m free space
(from widest point)
around it.
Cherub
Page 1 of 3
M10x100 Security Screw
x4
M6x20mm
Secure Screw
Eye Straps
Thread Lock Solution
Required (Not Supplied)
x2
KS1 –750mm
KS2 –900mm
Adult –1100mm
Metric Conversion:
500mm/ 20”
750mm/ 30”
900mm/ 35”
1100mm/ 43”
1.5m/ 59”
Spares available form
percussionplay.com or from your
local distributor
3.Locate Plates in desired
location and mark holes to fix
to desired surface.
M10 Barrel Nut
x2
M10x70 Security Screw
x2 Ground Anchors
not supplied
2 Part Cover Cap
x8
Surface Fix
Components:
5. Make sure all fixings are
covered and secure using
cover caps provided

Surface Fixed
Assembly Guide PPSWAV
22 Kg
BS EN 1176
Pair Small
Beaters X1
Cherub
Page 2 of 3
TX 45 Driver Bit
x2
TX 30 Driver Bit
x1
Tools:
Components:
M10x100 Security Screw
x4
M6x20mm
Secure Screw
Eye Straps
Thread Lock Solution
Required (Not Supplied)
x2
x4 Thread Lock Solution
Required (Not Supplied)
Spares available form
percussionplay.com or from your
local distributor
M10 Barrel Nut
x2
M10x70 Security Screw
x2 Ground Anchors
not supplied
2 Part Cover Cap
x8
Surface Fix
Components:
Saddle Strap X2
M6x20 Pin torx X4
COMPONENTS LIST:
M10x100 Pin torx X4
M10x70 Pin torx X2
M10 Barrel Nut Pin torx X2

Locate the Surface fix
Plate into the leg of the
instrument.
Fix instrument to Surface
fix plate using M10 bolt
and Barrel Nut and use
thread locking solution
to prevent fixings working
loose.
Fix Surface Plate to the
ground surface Ground
Anchors Not provided
cover fixings with caps
provided
Surface Fixed
Components:
Surface Fix Post Installation
(1.1)
1 2 3
Cherub
Page 3 of 3
M10 Barrel Nut
x2
M10x70 Security Screw
x2
TX 45 Driver Bit
Tools:
x2
BS EN 1176
Thread Lock Solution
Required (Not Supplied)
Thread Lock Solution
Required (Not Supplied)
2 Part Cover Cap
x8