Phase CI-MM3-II Configuration guide
Grille
Grillesafetyclip
Screws
Speaker
Two-gangjunctionbox(installersupplied)
NOTE: the CI-MM3-II is designed to install
into a standard 2-gang junction box. Phase
Technology recommends you test the t
before installing the junction box.
Box contents
1 Speaker
2 Grilles
4 Mounting screws
2 Wire nuts
©2010PhaseTechnology. Allrights reserved. Rev08.30.10
T E C H N O L O G Y
CI-MM3-II
Install instructions for Spacia models:
8005 W. 110th St. | Suite 208 | Overland Park, KS 66210 | 855.663.5600 | www.phasetech.com | www.mseaudio.com
1. Unpack speaker.
6. Done!
1.
2.
4. Attach grille safety clip by
placing the large end of the
clip over snap-t post (1),
then sliding clip until small
end snaps into place around
post (2).
5. Align tabs on snap-t grille
with slots in bae, gently
press grille into place.
Install instructions for Spacia models, Page 2
2. Connect speaker wires to
signal wires using included
wire nuts.
3. Install the CI-MM3-II into
the installer supplied
junction box using included
fasteners.
8005 W. 110th St. | Suite 208 | Overland Park, KS 66210 | 855.663.5600 | www.phasetech.com | www.mseaudio.com
Other Phase Speakers manuals
Phase
Phase CI60 VII CI CUSTOM INSTALL SERIES User manual
Phase
Phase PC0.5 User manual
Phase
Phase CI120 Original instructions
Phase
Phase CI X Series User manual
Phase
Phase CS-6R/Micro User manual
Phase
Phase CI110 II User manual
Phase
Phase CI140 User manual
Phase
Phase Velocity V52 User manual
Phase
Phase Velocity Series User manual
Phase
Phase Teatro Soundbar User manual
