Philadelphia Scientific HydroCart Max User manual

Philadelphia Scientific LLC. 207 Progress Drive Montgomeryville, PA 18936
P: 215.616.0390 F: 215.616.0500 www.phlsci.com
PAK462
Rev 02/2013
© 2013 Philadelphia Scientific LLC. All Rights Reserved. Philadelphia Scientific
and the PS logo are registered trademarks of Philadelphia Scientific LLC.
Water Injector System, Instant Valve PRO and HydroCart are trademarks of
Philadelphia Scientific LLC. E&O.E.
HydroCart Max
(Part Number INJ-HCT)
20 Gallon A/C Powered Mobile Water Supply
for Philadelphia Scientific Water Injector Systems™

Operation Instructions:
1. Connect the Instant Valve
Pro™to the Input Assembly
of the Water Injector System
installed on the battery.
2. Squeeze the lever
completely to fill the battery.
Do Not Partially Squeeze
the Lever.
3. Watch the spinner
mounted on the Instant
Valve Pro. When it stops
spinning, the filling is com-
pleted (about 15 seconds,
usually).
4. Release the lever and
then disconnect the Instant
Valve Pro from the Water
Injector System.
Installation Instructions:
1. Carefully remove the cart from
the shipping carton.
2. Fill the tank to the desired level
wth deionzied water.
3. Plug the HydroCart in to an
approved electrical outlet.
4. Turn the switch on to operate.
When all watering is complete,
turn the HydroCart off, disconnect
the power cord. Retract the power
cord and stow the output hose on
the hooks provided on the back of
the cart.