Philadelphia Scientific® Charger-Splitter™ Operations Manual
3. Troubleshooting
Use the following chart to help identify solutions to the most common issues.
•The white LED on a Sentinel™ flashes to
alert the operator to disconnect a charger
from a battery and plug it into a paired
battery. If both batteries are charged, no
white light will be on.
•Check the Sentinel™Outputs screen to
ensure that the Output Relay is set to
“Switch”.
•Use the buttons to scroll
through the options under Output Relay.
•Select the “Switch” option.
Power and Data
Connection Issues
Green LED –Communication status
•Off –No power to the Sentinel™.
•Solid –Sentinel™ is communicating properly with
Controller.
•Flashing –Sentinel™ is not communicating
properly with the Controller.
Amber LED –Charging status
•Off –No battery connected.
•Solid –Battery is connected.
•Solid –No battery connected. Check the charger
for a voltage leak to the DC cables.
Blue LED –Termination status
•Off –Battery is not at the top of the queue.
•Bright with Momentary Flashing –This is the
correct battery to pick next.
White Light is on for a
long time
•During normal operation, the white light will
go off after connection and charge start.
oIf the charger is still charging, leave
it connected.
oTroubleshoot charger if there is a
charger fault.
