Copyright © 2020, Fast ČR, a. s. Revision 08/2023
EN - 8
PART 4: BEFORE USING THE APPLIANCE
Preparing your dishwasher for rst
use
• Makesuretheelectricityandsupplywater
specications match the values indicated in the
installation instructions for the machine.
• Removeallpackagingmaterialinsidethe
machine.
• Setthewatersoftenerlevel.
• Filltherinseaidcompartment.
Salt usage
For a good washing function, the dishwasher needs
soft, i.e. less calcareous water. Otherwise, White lime
residues will remain on the dishes and the interior
equipment. This will negatively aect your machine’s
washing, drying and shining performance. When
water ows through the softener system, the ions
forming the hardness are removed from the water
and the water reaches the softness required to
obtain the best washing result. Depending on the
level of hardness of the inowing water, these ions
that harden the water accumulate rapidly inside the
softener system. Therefore, the softener system has
to be refreshed so that it operates with the same
performance also during the next wash. For this
purpose, dishwasher salt is used.
Machine can only be used by special dishwasher salt
to soften the water. Do not use any small grained
or powdered type of salts which can easily soluble.
Using any other type of salt can damage your
machine.
Fill the salt
To add softener salt, open the salt compartment cap
by turning it counter clockwise. (1) (2) At rst use, ll
the compartment with 1 kg salt and water (3) until it
is almost overowing. If available, using a funnel (4)
will make lling easier. Replace the cap and close it.
After every 20-30 Cycles add salt into your machine
until it lls up (approx. 1 kg).
!!!
The salt compartment should only be lled with
water when the appliance is used for the rst
time.
Only salt intended for use in dishwashers should
be used.
When salt overows and gets out of the salt
container, launch a short washing programme
to protect the dishwasher from corrosion.
Otherwise there is a risk of corrosion forming in
the dishwasher.
