Philco PC900SLE User manual

USER MANUAL
用戶手冊
PC900SLE

Dear Customer
Thank you for buying our hood. Please read these instructions carefully for
its optimum installation, use and maintenance.
Notes: The figures mentioned in this manual are in the first pages.
Hood installation on walls (look for the symbol in the figures)
Warning: consult local regulations regarding fumes outlets. Do not
connect the hood to a fume, ventilation or hot air duct. Confirm that room
ventilation is appropriate with the local authorities. Make sure the maximum
air extraction flow rate for the appliances in the room does not exceed 4 Pa
(0.04 mbar). The room must have adequate ventilation if an extractor hood
is used simultaneously with appliances that run on gas or other fuels. The
evacuated air must be extracted through ducts that are used for evacuating
fumes from appliances that run on gas or other fuels. Regulations regarding
air extraction must be complied with.
Use a venting hose with a min. diameter of 125mm to evacuate fumes
outside.
The above restrictions do not apply to hoods with no fumes outlet to outside
(recirculation system with activated charcoal filter).
Install the hood in line with the instructions on the template provided.
For gas cooking appliances only: the minimum distance to the hood must be
at least 65 cm.
Connecting the hood to the grid
Warning: before connecting the hood: switch off the electricity supply
and check that the supplied voltage and frequency coincide with that
indicated on the appliance nameplate.
If the extractor hood has a plug, connect it to a power socket in line with
applicable regulations, located in an accessible area.
If the hood does not have a plug, connect it directly to the electrical grid
protected by a separator device accessible for disconnection, in line with
local regulations.
EN

Use of the hood - Safety
Warning: the hood may stop working during an electrostatic
discharge (e.g. lighting). This involves no risk of damage. Switch off the
electricity supply to the hood and reconnect after one minute.
Do not allow the hood to be used by children or persons with reduced
(physical, sensory or mental) capabilities or lack of experience and
knowledge unless they have been given instruction concerning use of the
appliance by a person responsible for their safety.
Children should be supervised so that they do not play with the appliance.
To avoid the risk of fire, clean the metal filter regularly, permanently
control pans containing hot oil and do not flame food underneath the
hood.
Do not use the hood if it shows signs of damage or imperfection. Contact
an official distributor or Customer Service.
Accessible parts may heat up when using cooking appliances.
EN
Use of the Hood
Touch Control Panel
1 – Filter clean warning display/button.
Warning of the need to replace the filter – press to deactivate once the
filter has been cleaned or replaced.
2 – Enable and disable extractor fan timer.
3 – Lighting on and off. Keep pressed down to adjust the lighting
intensity.
4 – On/Off button
5 – Fan speed – 1, 2 and 3.
Timer: the extractor fan works for 5 min. at the current speed and another
5 min. at each of the lower speeds until it stops.

Hood Maintenance
Warning: always switch off the electricity supply before carrying out
maintenance work on the hood. In the event of a fault, contact an official
distributor or Customer Service.
Exterior Cleaning : Use non-corrosive, liquid detergent and avoid the use of
abrasive cleaning products.
Grease Filters Cleaning : To avoid fires, clean thoroughly once a month or
whenever the display pilot light indicates as such. To do so, remove the
filters and wash with hot water and detergent. If using a dishwasher, position
the filters vertically to prevent solid remains from depositing on them. Do not
use polish to clean or shine.
Activated charcoal filters : Replace every 3 months.
Important: increase the filter cleaning/replacement frequency if the
hood is used for more than 2 hours a day. Always use genuine filters from
the manufacturer.
Bulb Replacement (Look for the symbol in the figures)
Warning: do not handle the bulbs until the electricity supply has been
switched off and they have cooled.
Important: use new bulbs according to that indicated on the hood
nameplate.
Legal Information
The manufacturer:
- Declares that this product meets all basic requirements regarding low-
voltage electrical equipment established in Directive 2014/35/EU of 29
March 2014 and electro-magnetic compatibility established in Directive
2014/30/EU of 29 March 2014.
- Is not responsible for any failure to observe the instructions given in this
manual and current safety regulations for the correct use of the equipment.
- Reserves the right to make any modifications to the equipment or this
manual without prior notice.
Contact our official distributor or Customer Service should you require
technical assistance or additional information on our products.
EN

親愛的用戶:
感謝您購買飛歌牌抽油煙機產品。 為了達到最佳的安裝、使用及保養效果，
請您仔細閱讀本用戶手冊。
說明: 本手冊第一頁包括了所有的圖示。
安裝抽油煙機 (請參考圖示中 的符號說明 )
注意事項:請參考您當地有關於油煙排放標準的規定。 請勿將抽油煙
機與其他排煙管道、通風管道或熱風管道連接。 請向當地權威機構確認室內
通風條件是否適合安裝。請確保室內家用電器的最大排氣風壓率不超過
4Pa(0.04mbar)。 如果抽油煙機需要與其他燃氣設備一同使用，必須遵照有
關排氣標準的規定。
請使用最小直徑 125mm 作為室外排煙喉。
以上要求並不適用於室內循環式無排煙系統的抽油煙機(須配備活性炭過濾網
同時使用)。
請遵照圖例 中的說明及圖一至圖十六的圖示安裝抽油煙機。
如果燃氣爐與抽油煙機之間的距離(如圖三)大於圖例所顯示的距離，請遵照
爐具電器生產商的指示。一般燃氣爐與抽油煙機之間的最少距離必須為65厘
米。
初次使用抽油煙機
注意事項:在初次使用抽油煙機前，請先關閉供電電源，檢查供電電壓與
電流是否符合抽油煙機銘牌上所顯示的規定。
如抽油煙機是付有插頭，請遵照本地法規將其連接至附近的電插座。
如抽油煙機不付插頭，請遵照本地法規將其直接連接至具斷路器裝置保護的
電源座。
中文

安全使用抽油煙機說明
注意事項:抽油煙機可能會在靜電放電時停止工作(如閃電時)。這不會
造成抽油煙機的損壞。此時，請把電源關掉，等一分鐘後再重新開啟。
請勿讓兒童、障礙人士(包括生理、感官、心理)或缺乏知識經驗者使用，
必須有人在旁指導，保證其安全使用抽油煙機。
應注意照顧兒童，防止兒童玩弄設備。
為避免火災危險，請定期清洗金屬過濾網及長期積聚油漬的抽油煙機控制
面板。切勿在抽油煙機下方直接燒烤食物。
若發現抽油煙機出現損壞或瑕庛，請勿使用。應聯絡顧客服務部，讓技術
人士檢查。
在使用燃氣爐具時，附近的零部件可能會受熱。
中文
控制面版
輕觸式控制面版
1 – 金屬過濾網清潔提示。
當金屬過濾網需要清洗或更換時會亮起發出 提示。清潔或更換過濾網後，
接下按鍵以關閉警示。
2 – 時間掣 – 用以設定抽油煙機開/關時間。
3 – 照明燈開關掣 – 接任照明燈開關鍵, 可調節照明燈的亮度。
4 – 開關掣
5 – 風速鍵 –三段風速選擇。連續按風速鍵可以關閉抽油煙機。