Philips AJ3226/93 User manual

Register your product and get support at AJ3226
EN User manual
ZH-CN 用户手册

FM
MW
MHz
KHz
x10
ALARM 2
ALARM 1
SLEEP
UP DOWN
ALARM RESET
REP
•SLEEP OFF•
EA T ALARM
CLOCK
SETAL 1
SET AL2
SETTIME
AL 1
OFF
BUZZ
RADIO
TUNING
MW
FM
BAND
VOL
AUX
RADIO
OFF
CLOCK RADIO AJ 3226
AL 2
OFF
BUZZ
RADIO
3
1
2
8
7
6
5
0
9
4
@
!
$
%
^
#
1

EN
Congratulations on your purchase, and welcome to Philips!
To fully benet from the support that Philips offers, register your
product at www.philips.com/welcome.
Controls (see g. 1)
aSLEEP
• activates the radio for sleep function
• adjusts the sleep period
bClock control
• SET TIME: sets the clock time
• SET AL 1: sets the alarm time for alarm 1
• SET AL 2: sets the alarm time for alarm 2
• CLOCK: to run on clock time
cUP / DOWN
• adjusts the hours/ minutes for the clock and alarm times
dREPEAT ALARM / SLEEP OFF
• switches off the active alarm for a 6-7 minute period
• switches off the sleep function
eFrequency indicator
• shows the radio frequency of your selected waveband
fTUNING
• tunes to radio stations
gBAND
• select FM/MW waveband
hVOLUME
• adjusts the sound level

iALARM RESET
• stops the active alarm for 24 hours
jDISPL AY
• show the clock/ alarm times and status of the set
k OFF • RADIO • AUX
• switches off the set or selects the radio/AUX mode.
l AL 1, AL 2
• OFF switches off the alarm 1 or alarm 2
• RADIO activates the radio for alarm 1 or alarm 2
• BUZZ activates the buzzer for alarm 1 or alarm 2
mBattery door
• opens to store a 9 volt 6F22 type battery (not included) for
clock memory backup
nMains lead
• for AC mains supply
o Pigtail aerial
• improves FM reception
p AUX
• connects external audio source.
Installation
Power supply
1Check if the mains supply, as shown on the type plate located
on the bottom of the set, corresponds to your local mains
supply. If it does not, consult your dealer or service centre.
2Connect the mains lead to the wall socket.

3To disconnect the set from the mains supply completely,
remove the plug from the wall socket.
Note
•The type plate is located on the bottom of the set.
Clock memory backup
The clock memory backup allows your alarm and clock time settings
to be stored for up to a day when there is a power interruption e.g.
mains failure. The complete clock radio and display illumination will
be switched off. As soon as the mains supply returns, the display will
indicate the correct time.
1Remove the battery door to insert a 9 volt 6F22 type battery
(not included) for backup.
2Replace the battery door.
Note
•If no backup battery is installed or the power interruption is
prolonged, you will need to set the clock and alarm times again.
•Batteries contain chemical substances so should be disposed of
properly.
Radio
You can use this set solely as a radio!
1Adjust OFF • RADIO • AUX to RADIO to switch on the radio.
2Select your waveband by adjusting the BAND switch.

3Adjust TUNING to tune to your desired station.
4Turn the VOLUME control to adjust the volume level.
5Adjust OFF • RADIO • AUX to OFF to switch off the radio.
To improve reception:
FM: extend and position the pigtail for optimum reception.
MW: uses a built-in aerial inside the set. Direct the aerial by adjusting
the position of your set.
Setting the clock and alarm time
The time is displayed using the 24-hour clock
Note
•To adjust the clock and alarm times accurately, always make sure you
press UP / DOWN separately and not simultaneously.
1Turn the clock control to SET TIME or SET AL 1 or SET AL 2
to set the clock or alarm time respectively.
2Press UP/DOWN repeatedly or hold down on the respective
button to adjust the hours and minutes.
3Release UP/DOWN when you reach the correct setting.
4After you have set both the hour and minutes, turn the clock
control to CLOCK to run on clock time.

Selecting the alarm mode
GENERAL
If you wish to use the alarm, you must rst set the alarm time rst.
You can choose from two different alarm modes to wake you up: by
radio or buzzer.
• Select your choice of alarm mode by adjusting AL 1 or AL 2 to
RADIO or BUZZ.
»The buzzers are at a set volume and cannot be adjusted. BUZZ
on AL 1 is a low tone buzzer while BUZZ on AL 2 is a high
tone.
Switching off the alarm
There are three ways of switching off the alarm. Unless you cancel
the alarm completely, the 24 hour alarm reset option will be
automatically selected after 59 minutes, from the time your alarm
time rst goes off.
24 HOUR ALARM RESET
If you want the alarm mode to be stopped immediately but also wish
to retain the same alarm setting for the following day:
• Press ALARM RESET during the alarm call.
Canceling the alarm completely
To cancel the set alarm time before it goes off, or during the alarm
call:
• Adjust AL 1 or AL 2 to OFF position.

Repeat alarm
This repeats your alarm call at 6-7-minute intervals.
1During the alarm call, press REPEAT ALARM/SLEEP OFF.
SLEEP
About Sleep
This set has a built-in timer which enables the set to be automatically
switched off during radio playback after a set period of time. This
allows you to lie back, listen and fall asleep. The maximum sleep time
is 59 minutes.
Setting SLEEP
1Check that the clock control is in CLOCK position.
2Set OFF • RADIO • AUX to OFF position.
3To set the sleep function, do one of the following:
• Press and hold SLEEP.
»The display will begin to count down from 0:59 to 0:00
minutes.
• Hold down SLEEP, and press UP/DOWN repeatedly to adjust
sleep time from 59 minutes downward.
»To cancel sleep, press REPEAT ALARM/SLEEP OFF.
Connecting an external device
You can listen to your favorite music of the connected external
device through your AJ3226’s speakers.
1Adjust OFF • RADIO • AUX to select AUX.

2Connect the AUX-IN cable of the set to an AUDIO OUT or
headphone jack on an external device (such as MP3 player, or
CD player).
Safety information
• Install the unit near the AC outlet and where the AC plug can be
easily reached.
• Where the MAINS plug is used as the disconnect device, the
disconnect device shall remain readily operable.
• Place the set on a hard and at surface so that the system does
not tilt.
• If you do not intend to use the set for a long time, withdraw the
power plug from the wall outlet. In addition to this, it is advisable
to remove the battery from the clock radio. This will prevent any
danger of leakage and the clock radio will not be damaged.
• Do not expose the set, batteries to humidity, rain, sand or
excessive heat caused by heating equipment or direct sunlight.
• The apparatus shall not be exposed to dripping or splashing.
• Adequate ventilation with a minimum gap of 15cm between
the ventilation holes and surrounding surfaces is necessary to
prevent heat build-up.
• The ventilation should not be impeded by covering the
ventilation openings with items, such as newspapers, table-
cloths, curtains, etc..
• No objects lled with liquids, such as vases, shall be placed on
the apparatus.
• No naked ame sources, such as lighted candles, should be
placed on the apparatus.
• To clean the set, use a soft, slightly dampened chamois leather.
Do not use any cleaning agents containing alcohol, ammonia,
benzene or abrasives as these may harm the housing.

• Battery shall not be exposed to excessive heat such as sunshine,
re or the like.
Caution
•Use of controls or adjustments or performance of procedures other
than herein may result in unsafe operation.
Troubleshooting
If a fault occurs, rst check the points listed below before taking the
set for repair.
If you are unable to remedy a problem by following these hints,
consult your dealer or service center.
Warning
•Under no circumstances should you try to repair the set yourself, as
this will invalidate the warranty. Do not open the set as there is a risk
of electric shock.
Problem
– Possible Cause
• Remedy
No sound/power
– Volume not adjusted
• Adjust the volume
Occasional crackling sound during FM broadcast
– Weak signal
• Adjust the position of the Pigtail