Philips AJ7000/12 User manual

Register your product and get support at AJ7000
EN User manual

a
b
c
d
e
f
g
h
i
j
k
l
A

m
n

2
3
1
B
C

D
E

EN
1 Important
Safety
 Read these instructions.
 Heed all warnings.
 Follow all instructions.
 Do not block any ventilation openings. Install in accordance
with the manufacturer’s instructions.
 Do not install near any heat sources such as radiators, heat

that produce heat.
 Protect the power cord from being walked on or pinched,
particularly at plugs, convenience receptacles, and the point
where they exit from the clock radio.
 
manufacturer.
 Unplug this clock radio during lightning storms or when
unused for long periods of time.
 
is required when the clock radio has been damaged in any
way, such as power-supply cord or plug is damaged, liquid
has been spilled or objects have fallen into the clock radio,
the clock radio has been exposed to rain or moisture, does
not operate normally, or has been dropped.
 This clock radio shall not be exposed to dripping or
splashing.

 Do not place any sources of danger on the clock radio (e.g.

 Where the plug of the Direct Plug-in Adapter is used as
the disconnect device, the disconnect device shall remain
readily operable.
2 Your clock radio
Congratulations on your purchase, and welcome to Philips! To fully

www.philips.com/welcome.
Introduction
With this clock radio, you can:
 listen to FM/MW radio;
 set two alarms; and
 wake up to buzzer or radio.
What’s in the box
Check and identify the contents of your package:
 
 Adapter
 User manual

Overview of the main unit A
aSLEEP
 
bMain knob
 Adjust volume.
 
 Adjust settings.
cTIME ZONE
 
dFM/MW
 
eSET TIME/PROG
 
 Program radio stations.
fAL1/AL2
 
 View alarm settings.
 Activate/deactivate alarm timer.
gSNOOZE/BRIGHTNESS
 
 Adjust display brightness
hTUNING MODE
 
iPRESET
 
jDST
 

kAC 6V ~ 450mA
 Connect power.
lFM ANT
 Improve FM reception.
mBattery tray
nDisplay panel
 
3 Get started
Always follow the instructions in this chapter in sequence.
Install battery B
Caution
 Risk of explosion! Keep batteries away from heat, sunshine or

 Danger of explosion if battery is incorrectly replaced. Replace
only with the same or equivalent type.
 The battery contains chemical substances, so it should be
disposed of properly.
 Keep children away from the battery.
Note
 You can only use AC power as power supply. The pre-installed
lithium CR2032 battery can only back up clock and alarm settings.
When the low battery indicator is displayed, replace the battery as
indicated.

Connect power C
Caution
 Risk of product damage! Ensure that the power voltage
corresponds to the voltage printed on the back or underside of
the clock radio.
 Risk of electric shock! When you unplug the AC adapter, always
pull the plug from the socket. Never pull the cord.
Warning
 
clock radio to rain or moisture.
Plug and set
Time has been preset at the factory.When power is connected, the
set time is displayed automatically.
The built-in lithium battery can maintain clock setting despite power
interruption.