ENGLISH
Step
A
Connect the supplied mains adapter to the•
set's 9V DC jack and the plug into a wall outlet.
Step
B
How to set the Clock & Alarm time
Press and hold1. SET TIME or 1 ALM/2 ALM
until the hour digits flash.
Press and hold2. ∞§to adjust time.
Press3. SET TIME or 1 ALM/2 ALM to confirm.
Repeat the•steps 2-3 to complete all the
other time items setting.
Selecting the Alarm mode
4. Press ∞§/SOURCE repeatedly to select
your desired alarm mode.
•
For Nature sound mode, press ALBUM/PRESET
-/+ 1/2to select your desired nature sound track.
Helpful hints:
If you have selected– TUNER alarm mode, make
sure you have properly tuned to a station before
turning off the set (See Tuning to radio station).
If you have selected iPod/USB alarm mode,–
make sure you have connected the compatible
iPod player or USB device, or the buzzer mode
will be selected automatically.
3 ways to switch off the alarm
Either press briefly:•POWER 2or REPEAT
ALARM/BRIGHTNESS CONTROL.
Press•1 ALM or 2 ALM.
Step
C
Tuning to radio station
Press1. SOURCE once or more to switch on
the radio.
Press2. ∞§repeatedly to tune to your
station.
To store a preset, press•PROG to activate the
programming, and then press ALBUM/PRESET
-/+ 1/2to select a desired preset number, and
then press PROG again to confirm.
To store preset radio stations automatically, press•
and hold PROG for more than two seconds.
Step
D
Playing Apple iPod using DC200
Remove the top cover of dock.1.
Snap the correct adaptor (supplied) into the2.
dock to provide a snug fit for the iPod player.
The indication on the adaptor’s back fits•
specific iPod player.
3. Snap the compatible iPod into the dock
connector.
4. Press SOURCE repeatedly to select the iPod
mode.
The connected player will play automatically.•
Helpful hints:
By using the buttons (– 2;,
∞
,
§
and
VOLUME ) on the DC200, the following iPod
playback features are available: Play/Pause,
selecting next/previous track, fast forwarding/
rewinding and changing volume.
Refer to the user manual supplied for detailed–
descriptions of “Compatible portable player”,
“Selecting the correct dock adaptor” and the
important notes for dock operation.
Step
E
Playing a USB mass storage device
Make sure that your DC200 is being powered1.
by AC mains.
Press2. SOURCE repeatedly to select the USB
mode.
Plug a compatible USB mass storage device to3.
DC200’s USB port marked .
Playback will start automatically.
Ü
