Philips AD330/12 User manual

Register your product and get support at
www.philips.com/welcome
AD330 (Black)
AD333 (White)
EN User manual

2EN
Contents
1 Important 3
2 Your Docking Speaker 3
Introduction 3
What's in the box 3
Overview of the main unit 4
3 Get started 5
Connect power 5
4 Play 5
Play from iPod/iPhone 5
Play from an external audio device 6
5 Product information 6
 
6 Troubleshooting 7
7 Notice 7
Disposal of your old product 8

3EN
1 Important
 Read these instructions.
 Heed all warnings.
 Follow all instructions.
 Do not use this apparatus near water.
 Do not block any ventilation openings.
Install in accordance with the
manufacturer's instructions.
 Do not install near any heat sources such
as radiators, heat registers, stoves, or

produce heat.
 Protect the power cord from being
walked on or pinched, particularly at plugs,
convenience receptacles, and the point
where they exit from the apparatus.
 
by the manufacturer.
 Unplug this apparatus during lightning storms
or when unused for long periods of time.
 
personnel. Servicing is required when
the apparatus has been damaged in any
way, such as power-supply cord or plug
is damaged, liquid has been spilled or
objects have fallen into the apparatus, the
apparatus has been exposed to rain or
moisture, does not operate normally, or
has been dropped.
 Apparatus shall not be exposed to
dripping or splashing.
 Do not place any sources of danger on the

candles).
 Where the plug of the Direct Plug-in
Adapter is used as the disconnect device,
the disconnect device shall remain readily
operable.
Warning
 Never remove the casing of this apparatus.
 Never place this apparatus on other electrical
equipment.
 Ensure that you always have easy access to the power
cord, plug or adaptor to disconnect the apparatus from
the power.
2 Your Docking
Speaker
Congratulations on your purchase, and

support that Philips offers, register your product
at www.philips.com/welcome.
If you contact Philips, you will be asked for the
model and serial number of this apparatus.The
model number and serial number are on the
bottom of the apparatus.Write the numbers
here:
Model No. __________________________
Serial No. ___________________________
Introduction
With this docking speaker, you can enjoy audio
from the iPod/iPhone, and other external audio
devices.
What's in the box
Check and identify the contents of your
package:
 Main unit
 AC power adaptor
 Quick start guide
 Safety sheet.

4EN
Overview of the main unit
a
 Mute sound.
b Dock for the iPod/iPhone
c
 Start or pause play.
d VOL +/-
 Adjust volume.
e MP3-LINK
 Connect an external audio device.
f DC IN
 Connect AC power.
ad
c
b
fe

5EN
3 Get started
Always follow the instructions in this chapter in
sequence.
Connect power
Caution
 Risk of product damage! Make sure that the power
supply voltage matches the voltage printed on the
bottom of the docking speaker.
 Risk of electric shock! When you unplug the AC
adaptor, always pull the plug from the socket. Never
pull the cord.
Connect the AC power adaptor to:
 the DC IN socket at the back of the
docking speaker.
 the wall outlet.
DC IN
4 Play
Play from iPod/iPhone
You can enjoy audio from your iPod/iPhone
through this docking speaker.
Compatible iPod/iPhone
The docking speaker supports the following
iPod and iPhone models:
Made for.
 iPod touch (1st, 2nd, 3rd, and 4th
generation)
 iPod classic
 iPod nano (1st, 2nd, 3rd, 4th, 5th, and 6th
generation)
 iPhone 4S
 iPhone 4
 iPhone 3GS
 iPhone 3G
 iPhone
Listen to the iPod/iPhone
1 Place an iPod/iPhone in the dock.
2 Play audio on the iPod/iPhone.
3 To adjust volume, press VOL +/-.
4 To mute, press .

6EN
To remove the iPod/iPhone:
Pull the iPod/iPhone out of the dock.
Charge the iPod/iPhone
When the docking speaker is connected to
power, the docked iPod/iPhone begins to
charge automatically.
Play from an external audio
device
Note
 Make sure that no iPod/iPhone is docked in the speaker.
1 Connect an MP3 link cable (not supplied)
to:
 the MP3 LINK socket at the back of
the docking speaker.
 the headphone socket on an external
device.
2 Press to play music on the device (see
the device's user manual).
5 Product
information
Note
 Product information is subject to change without prior
notice.


Total Output Power 8W
Signal to Noise Ratio > 62 dBA
MP3 Link 650mV RMS
General information
AC Power Model: AS110-080-
AE130 (Philips);
Input: 100-240 V ~,
50/60Hz, 0.5A;
Output: 8.0 V 1.3 A
Operation Power
Consumption 15 W
Standby Power
Consumption <0.5 W
Max. load for iPod/
iPhone 5 V 1 A
Dimensions
- Main Unit
(W x H x D) 261 x 130 x 103 mm
Weight
- Main Unit
- With Packing
0.9 kg
1.5 kg

7EN
6 Troubleshooting
Warning
 Never remove the casing of this apparatus.
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
apparatus, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips web site
(www.philips.com/support).When you contact
Philips, ensure that the apparatus is nearby
and the model number and serial number are
available.
No power
Ensure that the AC power adaptor of the
unit is connected properly.
Ensure that there is power at the AC
outlet.
No sound
Adjust the volume.
No response from the unit
Disconnect and reconnect the AC power
adaptor, then turn on the unit again.
7 Notice

device that are not expressly approved by
Philips Consumer Lifestyle may void the user’s
authority to operate the equipment.
This product complies with the radio
interference requirements of the European
Community.
“Made for iPod” and “Made for iPhone”
mean that an electronic accessory has been


the developer to meet Apple performance
standards. Apple is not responsible for the
operation of this device or its compliance with
safety and regulatory standards. Please note that
the use of this accessory with iPod or iPhone
may affect wireless performance.
iPod and iPhone are trademarks of Apple Inc.,
registered in the U.S. and other countries.

8EN
Disposal of your old product
Your product is designed and manufactured
with high quality materials and components,
which can be recycled and reused.
Never dispose of your product with other
household waste. Please inform yourself about
the local rules on the separate collection of
electrical and electronic products and batteries.
The correct disposal of these products helps
prevent potentially negative consequences on
the environment and human health.
Please visit www.recycle.philips.com for
additional information on a recycling center in
your area.
Environmental information
All unnecessary packaging has been omitted.
We have tried to make the packaging easy to
separate into three materials: cardboard (box),
polystyrene foam (buffer) and polyethylene
(bags, protective foam sheet.)
Your system consists of materials which can
be recycled and reused if disassembled by
a specialized company. Please observe the
local regulations regarding the disposal of
packaging materials, exhausted batteries and old
equipment.

Specifications are subject to change without notice
© 2012 Koninklijke Philips Electronics N.V.
All rights reserved.
AD330/AD333_12_UM_V1.0