Philips DVP3005/05 Quick start guide

Philips Electronics Singapore
BLC AV Systems
Software Upgrade Instructions
For
Philips DVD Players:
• DVP3005/00
• DVP3005/05
Prepared by Ivan Chan

Philips Electronics Singapore Software Upgrade Instruction
1 Introduction
The upgrade version of this software is Version 00.05.01.0D
This software can be used to upgrade the following Philips DVD Players:
• DVP3005/00
• DVP3005/05
After you have completed the upgrade procedure, your DVD player will typically
perform better. What improvements are made depends on the upgrade software
you are using as well as the software that your DVD player contained before the
upgrade.
2 Key Features
This software version includes:
Fix the problem of the Player switches on from Standby by itself.
3 Preparations
You will need the following items:
• Personal Computer
• CD-R/RW drive and writing application software
• 1x blank CD-R or CD-RW
Prepared by Ivan Chan 2of 4

Philips Electronics Singapore Software Upgrade Instruction
4 Software Version Verification Procedure
It’s important to write down the Software Version information of your DVD player
before you start the upgrade procedure. This information is also useful in case
you need to call Philips Customer Care Center.
• POWER ON the set.
• Press SYSTEM MENU key to enter SETUP menu
• Press <or >to navigate to GENERAL menu
• Press keys 1,3,7,9 successively. Version table will be displayed on screen.
Version 00.05.01.0D (Software Version)
SUB-VER XX.XX.XX.XX
8032 XX.XX.XX.XX
Servo XX.XX.XX.XX
RISC XX.XX.XX.XX
DSP XX.XX.XX.XX
Region Code X
5 Software Filename Verification Procedure
• Open the tray
• Press key 5, 5
• Upgrade file name will be displayed on the TV Screen.
6 Download Software
1. Click the link to save the software on your computer.
2. Unzip the .zip file and extract files into your PC.
3. Check the file name of the .BIN file. Make sure it’s the same as the one shown
on the TV Screen described in Section 5.
Prepared by Ivan Chan 3of 4

Philips Electronics Singapore Software Upgrade Instruction
7 Steps to Upgrade Software
1. Burn the files to blank CD-R or CD-RW, not a DVD, using the following
settings:
• File System CD-ROM ISO Level 2
• Mode 1/2/XA
• Character set ISO 9660
• Finalized, single session
• Write speed slow (e.g. 2x, 4x)
Finalize the disc. (The application may do this automatically.)
NOTE: Packet writing application for drag & drop copying cannot be used
for creating an upgrade disc. Use only a dedicated CD writing application
allowing ‘disc at once’ recording.
No UDF setting as well.
2. Power on the set
3. Put in the disc
4. A message will be displayed on the OSD after the upgrade file is recognized
5. Follow the instruction displayed on the TV Screen – Press “OK” to upgrade
6. After reading the file, the disc will be ejected
7. Remove the disc, but DO NOT close the tray
8. Wait approximately 3-5 minutes for the software to be upgraded
9. The set will restart itself once the upgrade is completed.
Caution: Do not unplug or power off the set while upgrading in
progress.
8 After the upgrade
Do check the Software Version to confirm the upgrade.
Please follow the procedure described in the Section 4.
9 Software History
Software Version Number 00.05.01.0D
• Fix the problem of the Player switches on from Standby by itself.
Prepared by Ivan Chan 4of 4