Philips MDV560VR Quick start guide

1. Introduction
The upgrade version of this software is Version 1.405
__________________________________________________________________
2. Key Features added in this software version
This software version includes:
• Fixed audio distortion (1KHZ) 2ch OSD LPCM 3/2.1ch
• VCD playback from the start point when we do time-search.
__________________________________________________________________
3. Software Upgrade Disc Preparation
Tools Required
You will need the following items :
· a personal computer
· a CD-R/RW drive and writing application software
· a blank CD-R
__________________________________________________________________
4. How to download the software to your computer
1) Click the link to save the software on your computer.
2) Unzip the .zip file and extract files into your PC.
Do not change the filenames “lgtest.img”
__________________________________________________________________

5. Software Version Verification Procedure
It is important to write down the system version information of your set before you
start the upgrade procedure. This information is also useful in case you need to
call Philips Customer Care Center.
1) Press SETUP button on the remote control
2) Press ▼to select TV ASPECT
3) Press ►to select 16:9 Wide
4) Press ENTER
5) Press the number key 1, 3, 9, 7, 1, 3, 9
6) Press ENTER
__________________________________________________________________

6. Steps to upgrade MDV560VR/17
1. Burn the files to blank CD R or CDRW, using the following settings :
· File System CD-ROM ISO Level 2
· Mode 1/2/XA
· Character set ISO 9660
· Finalised, single session
· Write speed slow (e.g. 2x, 4x)
Finalize the disc. (The application may do this automatically.)
NOTE : Packet writing application for drag & drop copying cannot be used
for creating an upgrade disc. Use only a dedicated CD writing application
allowing ‘disc at once’ recording.
No UDF setting as well.
2. Power up the set.
3. Insert the CD that contain “lgtest.img” file to DVD player
4. Wait for a few minutes until you find the message Firmware Upgrade :
“Cancel” and “Start” on your TV screen. Move the cursor to Start and
press OK button on your remote control. Then the firmware starts and wait
for a few minutes.
5. When the door tray opened, take off the disc and wait for a few minutes and
don’t touch anything until product logo show on your TV screen.
6. Upgrade process is finished and you can enjoy your DVD player now.

__________________________________________________________________
7. After the upgrade
Do confirm the software version by checking the system version.
Please follow the procedure described in the section “Software Version
Verification Procedures”.
__________________________________________________________________
8. Firmware Upgrade History
V1.405
1. Fixed audio distortion(1KHZ) 2ch OSD LPCM 3/2.1ch
2. VCD playback from the start point when we do time-search
V1.324
1. The garbage track display when we insert the macrovision disc.
2. While playing VCD 2.0 which has selection list, We can't enter to play
mode during R-stop or scan although press "play" key.
V1.310
1. Fixed system hangs when we press zoom button in the Kodak P-CD Browser.
D302.2
1. Enable P.Scan -> Disable P.Scan. Then there's no video output. We fix this
problem.
2. We improved the problem which is green background can be seen while
escaping P.Scan mode.
3. We change the bmp of "ENTER" to "OK".
4. Video is broken for a while. If we do maker while scan play.
5. Fixed the MP3 files not to be played which bitrate under 32 Kbps.
6. Improve the readability of DVD-R.