Philips S5000 series User manual

4
Introduction
Congratulations on your purchase and welcome to
Philips! To fully benefit from the support that Philips
offers, register your product at
www.philips.com/
welcome
.
General description (Fig. 1)
1
Protection cap for cleansing brush attachment
)
(
specific types only
2
Click-on cleansing brush attachment
(
specific types only
)
3
Comb for beard styler attachment
(
specific types only
)
4
Click-on beard styler attachment
(
specific types only
)
5
Click-on trimmer attachment
(
specific types only
)
6
Protection cap for shaving unit
)
(
specific types only
7
Click-on shaving unit
8
On/off button
9
Turbo button (specific types only)
10
Handle
11
Socket for small plug
12
Battery charge indicator with 1 light
13
Battery charge indicator with 3 lights
14
Unplug for use symbol
15
Travel lock symbol
16
Replacement reminder
17
Cleaning reminder
18
Cleaning cartridge for SmartClean system
19
SmartClean system (specific types only)
20
Cap of SmartClean system
21
On/off button
22
Battery symbol
ENGLISH

ENGLISH 5
23 Cleaning symbol
24 Replacement symbol
25 Ready symbol
26 Adapter
27 Small plug
28 Pouch (specific types only)
Note: The accessories supplied may vary for different
products. The box shows the accessories that have
been supplied with your appliance.
Important safety information
Read this important information carefully before
you use the appliance and its accessories and save
it for future reference. The accessories supplied
may vary for different products.
Danger
- Keep the adapter dry.
Warning
-The adapter contains a transformer. Do not cut
off the adapter to replace it with another plug,
as this causes a hazardous situation.
-This appliance can be used by children aged
from 8 years and above and persons with
reduced physical, sensory or mental capabilities
or lack of experience and knowledge if they
have been given supervision or instruction
concerning use of the appliance in a safe way
and understand the hazards involved. Children
shall not play with the appliance. Cleaning and
user maintenance shall not be made by children
without supervision.
-Always unplug the shaver before you clean it
under the tap.
-Always check the appliance before you use it.
Do not use the appliance if it is damaged, as this

6 ENGLISH
may cause injury. Always replace a damaged part
with one of the original type.
Caution
-Never immerse the cleaning system or the
charging stand in water and do not rinse it
under the tap.
-Never use water hotter than 80°C to rinse the
shaver.
-Only use this appliance for its intended purpose
as shown in the user manual.
-For hygienic reasons, the appliance should only
be used by one person.
-Do not use the adapter in or near wall sockets
that contain or have contained an electric air
freshener to prevent irreparable damage to the
adapter.
-Never use compressed air, scouring pads,
abrasive cleaning agents or aggressive liquids
such as petrol or acetone to clean the appliance.
-If your shaver comes with a cleaning system,
always use the original Philips cleaning fluid
(cartridge or bottle, depending on the type of
cleaning system).
-Always place the cleaning system on a stable,
level and horizontal surface to prevent leakage.
-If your cleaning system uses a cleaning cartridge,
always make sure that the cartridge
compartment is closed before you use the
cleaning system to clean or charge the shaver.
-When the cleaning system is ready for use, do
not move it to prevent leakage of cleaning fluid.
-Water may drip from the socket at the bottom
of the shaver when you rinse it. This is normal
and not dangerous because all electronics are
enclosed in a sealed power unit inside the
shaver.

ENGLISH 7
Electromagnetic fields (EMF)
- This Philips appliance complies with all applicable
standards and regulations regarding exposure to
electromagnetic fields.

8 ENGLISH

ENGLISH 9
-

10 ENGLISH
-

ENGLISH 11
-

12 ENGLISH
-

Using the shaver
Switching the appliance on and off
1To switch on the appliance, press the on/off
button once.
2To switch off the appliance, press the on/off
button once.
- Battery charge indicator with 3 lights: The
display lights up for a few seconds to show the
remaining battery status.
Shaving

Skin adaptation period
Your first shaves may not bring you the result you
expect and your skin may even become slightly
irritated. This is normal. Your skin and beard need
time to adapt to any new shaving system.
We advise you to shave regularly (at least 3
times a week) with this shaver for a period of 3
weeks to allow your skin to adapt to the new
shaver.
Note: This appliance can only be used without a cord.
1Switch on the appliance.
2Move the shaving heads over your skin in
circular movements.
Note: Do not make straight movements.
3Clean the shaver after use (see chapter
‘Cleaning and maintenance’).
Wet shaving
You can also use this shaver in the shower or on a
wet face with shaving foam or shaving gel.

To shave with shaving foam or shaving gel, follow
the steps below:
1Apply some water to your skin.
2Apply shaving foam or shaving gel to your skin.
3Rinse the shaving unit under the tap to ensure
that the shaving unit glides smoothly over your
skin.
4Switch on the shaver.
5Move the shaving heads over your skin in
circular movements.
Note: Rinse the shaver under the tap regularly to
ensure that it continues to glide smoothly over your
skin.
6Dry your face and thoroughly clean the shaver
after use (see chapter ‘Cleaning and
maintenance’).
Note: Make sure you rinse all foam or shaving gel off
the shaver.

Using the trimmer attachment
You can use the trimmer attachment to groom
your sideburns and moustache.
1Make sure the appliance is switched off.
2Insert the lug of the attachment into the slot in
the top of the shaver. Then press down the
trimmer attachment to attach it to the
appliance (‘click’).
3Switch on the appliance.
4You can now start trimming.
5Clean the attachment after use (see chapter
‘Cleaning and maintenance’).
Using the beard styler attachment
1Make sure the appliance is switched off.
2Insert the lug of the attachment into the slot in
the top of the appliance. Then press down the
attachment to attach it to the appliance
(‘click’).
Using the beard styler attachment with
comb
You can use the beard styler attachment with
the comb attached to style your beard at one
fixed setting, but also at different length settings.
You can use it also to pre-trim any long hairs
before shaving to have a more comfortable
shave. The hair length settings on the beard
styler attachment correspond to the remaining
hair length after cutting and range from 1 to
5mm.

1Slide the comb straight into the guiding grooves
on both sides of the attachment
(‘click’).
2Press the length selector and then push it to
the left or right to select the desired hair length
setting.
3Switch on the appliance.
4You can now start styling your beard by
moving the attachment upwards with
gentle pressure making sure the front of
the comb is in full contact with the skin.
5Clean the attachment after use (see chapter
‘Cleaning and maintenance’).
Using the beard styler attachment without
comb
You can use the beard styler attachment without
the comb to contour your beard, moustache,
sideburns or neckline to a length of 0.5mm.
1Pull the comb off the attachment.
Note: Grab the comb in the centre to pull it off the
attachment. Do not pull at the sides of the comb.
2Switch on the appliance.
3You can now start contouring your beard,
moustache, sideburns or neckline by moving
the styler downwards with gentle pressure
while holding it perpendicular to the skin.
4Clean the attachment after use (see chapter
‘Cleaning and maintenance’).

Using the cleansing brush attachment
Use the rotating cleansing brush attachment with
your daily cleansing cream. The cleansing brush
attachment removes oil and dirt, contributing to a
healthy and oil-free skin.