Philips HP4879 User manual

Hydraprotect Salon 2000
HP4879

2

3

4

ENGLISH 6
POLSKI 13
ROMÂNĂ 21
РУССКИЙ 28
ČESKY 37
MAGYAR 44
SLOVENSKY 51
УКРАЇНСЬКА 59
HRVATSKI 68
EESTI 75
LATVISKI 82
LIETUVIŠKAI 89
SLOVENŠČINA 96
БЪЛГАРСКИ 104
SRPSKI 112
HP4879

Introduction
Naturally, healthy looking hair contains around 15% moisture. Scientific
tests have shown that continuously drying at a too high temperature
can lead to overdrying, in which case the moisture level of the hair falls
below the natural level of 15%. Hair that has been overdried feels
coarse and looks dull and frizzy.The Philips Hydraprotect Salon 2000 is
equipped with a unique sensor.The sensor technology provides
automatic feedback when your hair is dry; it starts working at a high
temperature to quickly dry wet hair and automatically adjusts to a
lower temperature when the hair is dry, which is shown by the
temperature indicator on the handle.The sensor technology combined
with an ultra strong airflow makes this hairdryer the quickest among
gentle hairdryers.The end result is beautiful shiny hair in top condition!
For more information on this hairdryer or any other Philips beauty
product, visit our web site: www.philips.com/beauty
General description
AAir inlet grille
BRocker switch for temperature settings
-fiQuick-Dry setting
-flHydraprotect setting
-—Cool setting
CAirflow and on/off slide
- O = off
- I = Low airflow especially intended for styling
- II = Medium airflow for drying and styling
- III = Ultra strong airflow for fast drying
DTemperature indicator
EHanging loop
FVolume diffuser
GConcentrator
HSensor
ENGLISH6

Important
◗Check if the voltage indicated on the appliance corresponds to
the local mains voltage before you connect the appliance.
◗Keep this appliance away from water! Do not use this product
near or over water contained in baths, washbasins, sinks etc.
When used in a bathroom, unplug the appliance after use since
the proximity of water presents a risk, even when the hairdryer is
switched off.
◗For additional protection, we advise you to install a residual
current device (RCD) with a rated residual operating current
not exceeding 30mA in the electrical circuit supplying the
bathroom.Ask your installer for advice.
◗Keep the appliance out of the reach of children.
◗Never block the air grilles.
◗If the appliance overheats, it will switch off automatically. Unplug
the appliance and let it cool down for a few minutes. Before you
switch the appliance on again, check the grilles to make sure they
are not blocked by fluff, hair, etc.
◗Always switch the appliance off before putting it down, even if it
is only for a moment.
◗Noiselevel: L= 86 dB(A) re 1pW
Using the appliance
Drying
1Put the plug in the wall socket.
2Switch the appliance on by setting the airflow slide to position I, II
or III.
3Select the desired airflow speed by setting the airflow slide to
position I, II or III. (fig. 1)
O = Off
I = Low airflow especially intended for styling
II = Medium airflow for drying and styling
III = Ultra strong airflow for fast drying
ENGLISH 7

4Select the desired temperature setting by pressing the rocker
switch.
The Quick-Dry setting
◗fiThe Quick-Dry setting enables you to dry shower-wet hair
very quickly. (fig. 2)
It is recommended to use the Quick-Dry setting only on shower-wet
hair to speed up the drying process.When the hair is almost dry, the
sensor automatically adjusts the temperature to a lower level to
prevent the hair from becoming overdried.
The Hydraprotect setting
◗flThe Hydraprotect setting can be used to dry towel-dry hair.
(fig. 3)
◗The temperature sensor constantly monitors the moisture
content of the hair during the drying process.The temperature
will be automatically adjusted to a lower, caring level to prevent
the hair from becoming overdried. (fig. 4)
Make sure there is no obstruction between your hair and the red
cover of the temperature sensor to avoid malfunctioning of the
appliance.
The Cool setting
◗—The Cool setting fixes the style you have created. (fig. 5)
For long-lasting styling results, set the rocker switch to the Cool setting
and direct the cool airflow at your hair to fix your style.
5Dry your hair by making brushing movements with the hairdryer
at a small distance from the hair. (fig. 6)
6Select the highest airflow speed (III) in combination with the
Quick-Dry setting for ultra-quick drying.
◗The temperature indicator shows the condition of the hair.When
the temperature indicator starts blinking, the hair is almost dry.
(fig. 7)
7Select a lower airflow speed (I-II) for drying short hair or styling
your hair.
ENGLISH8

Attachments
Concentrator
The concentrator enables you to direct the airflow straight at the brush
or comb with which you are styling your hair.
1Connect the concentrator by simply snapping it onto the
appliance. (fig. 8)
2Switch the appliance on by setting the airflow slide to position I, II
or III.
3While you are drying your hair with the concentrator, you can
use a brush or comb to style your hair. (fig. 9)
4Disconnect the concentrator by pulling it off the appliance.
Volume diffuser
The volume diffuser has been specially developed to gently dry both
straight and curly or wavy hair.
◗The volume diffuser emits a gentle airflow and allows you to give
your style volume and bounce. (fig. 10)
1Connect the diffuser by simply snapping it onto the appliance.
Disconnect it by pulling it off. (fig. 11)
◗To add volume at the roots, insert the pins into your hair in such
a way that they touch your scalp. (fig. 12)
2Make rotating movements with the appliance to distribute the
warm air evenly through your hair. (fig. 13)
Curly or wavy hair
◗(fig. 14)
- When you are styling curly or wavy hair, hold the diffuser at a
distance of 10-15 cm from your head to let the hair dry gradually.
- In the meantime you can style your hair with your free hand or
with a comb.
ENGLISH 9

- You can also scrunch locks of hair in your hand to shape the curls
and waves while drying.This will prevent the curls from sagging or
becoming frizzy.
Long hair
◗To dry long hair, you can spread out locks of hair on top of the
diffuser. (fig. 15)
◗Alternatively, you can comb the hair downwards with the pins of
the diffuser while drying. (fig. 16)
Styling and drying tips
Here is one style you can create easily and gently with the
Hydraprotect Salon 2000 hairdryer. As you become more familiar with
the appliance, you will discover many other ways to create great styles.
Just use your imagination!
1After washing and conditioning your hair as usual, start drying it
by dabbing the wet hair with a towel, then comb it through
carefully.
2Place the diffuser in your hair so that the tips of the air pins
touch your scalp. By making circular movements with the diffuser,
the hair will be lifted towards the base of the diffuser and the air
pins will dry the hair from the roots upwards.This will add more
volume to your hair. Continue drying until your hair is dry at the
roots.
3Set the airflow to a lower position and continue drying until your
hair is completely dry. Use a comb or brush to style your hair in
the desired way while drying.
4To create volume at the hair ends, hold the diffuser in horizontal
position and place some locks of hair on the base of the diffuser
between the air pins and leave them there for a while.The gentle
airflow will prevent your curls or waves from being blown out of
style while drying.
5Finish off with the cool airflow to fix your style.
Set the rocker switch to the Cool setting and direct the cool airflow at
your hair to fix your style.
ENGLISH10