Philips C3 Series User manual

C3 Series
Recessed Emergency Power for Egress Lighting
Page 1 of 2
Job Information Type:
Job Name:
Cat. No.:
Notes:
Features
Illumination: The C3 Series
is a suggested emergency
power source for the LP Series
interior/exterior low-level
LED luminaire, the LLEF Series
exterior wall/soffit remote, and
the LLRE Series recessed MR16
exterior remote (see back
page). Any 12 VDC remote
emergency luminaire can also
be powered by the C3 Series
power module.
Housing: The C3 Series
power module rough-in
enclosure is fabricated from
20 gauge die formed galvanized
steel. The trim plate is
fabricated from 12 gauge steel
and is painted with a matte
white powder coat finish. The
trim plate is also offered with
an optional matte black finish.
Knockouts for conduit as
well as screw hole knockouts
for mounting to joist are
conveniently located on the
back box.
Operating Temperature
Range: Standard Location
65°F (19°C) to 85°F (30°C)
Damp Location
50°F (10°C) to 104°F (40°C)
Electronics: 120/277 VAC,
60 Hz, dual input. The power
module utilizes an automatic
voltage regulated charging
system. The 2-state charger
eliminates the need for
periodic battery exercising. It is
recommended that a monthly
load test of a minimum of (1)
minute be performed and
recorded to satisfy NFPA 101
life safety requirements. A
momentary test switch and
normal power indicator lamp
are located on the trim plate
to assist testing and visual
inspection of the product. A
pre-wired plug in receptacle is
provided within the enclosure
for routing 12 VDC emergency
power to remote emergency
luminaires.
Electrical Specifications:
C3250
(120) 0.22 A, (277) 0.11 A
C3275
(120) 0.21 A, (277) 0.11 A
C3275DL
(120) 0.22 A, (277) 0.11 A
Code Compliance
UL 924 and optional UL damp
location listed. NFPA 101,
NEC, BOCA, OSHA and IBC
illumination standards.
Warranty
Three-year full electronics
warranty. One year full plus
four year prorated lead calcium
battery warranty.
C3250LW
5.75"
(14.6 cm)
5.63"
(14.3 cm)
4.5"
(11.4 cm)
9.5"
(24.1 cm)

C3 Series
Recessed Emergency Power for Egress Lighting
Page 2 of 2
Philips Lightolier
e: [email protected]
t: [phone]
w: www.lightolier.com
C3 Series May 18, 2012
Specifications are subject to change without notice.
© Koninklijke Philips Electronics N.V., 2012.All rights reserved.
Job Information Type:
Ordering Information
C3 = C3 Series
Power Module
Series
2= 12 V
DC Voltage
C3
50 = 50 W
75 = 75 W
Output Wattage
L= Lead Calcium
Battery
W= White
B= Black
Trim Cover Finish Accessories (order as a separate item)
BHK1 = Bar Hanger for Mechanical Ceilings
DL = Damp Location*
TD = Time Delay (15 min)
*Damp location available
on 50 W version only.
Factory Installed Options
2L
Recommended product selection to be used with the C3 Series
7.8 "
(19.81cm) 6.5"
(16.51 cm)
LLEF = Indoor/Outdoor
Remote Head
Series
1= Single Remote Head
2= Double Remote Head
# of Heads
LLEF
R= 4” Round
S= Single Gang Rectangular
Mounting Plate
BK = Black
BZ = Bronze
Finish
MR16 Halogen Lamps
Blank = No Lamps Installed
20WF = 12 Volt, 20 Watt Wide Flood 40°
35FL = 12 Volt, 35 Watt Flood 25°
35WF = 12 Volt, 35 Watt Wide Flood 40°
50FL = 12 Volt, 50 Watt Flood 25°
50WF = 12 Volt, 50 Watt Wide Flood 40°
MR16 LED Lamp1
7F2= 12 Volt, 7 Watt Flood 35°
Lamp Type
Accessories (order as a separate item)
LORBBK = Outdoor 4” Round Surface Mount Junction Box, Black
LORBBZ = Outdoor 4” Round Surface Mount Junction Box, Bronze
LOSBBK = Outdoor Single Gang, Surface/Recessed 2 3/4” x 4 1/2” Junction Box, Black
LOSBBZ = Outdoor Single Gang, Surface/Recessed 2 3/4” x 4 1/2” Junction Box, Bronze
LLEF Series
LLRE Series 4.69"
(11.9 cm)
LLREBK = Outdoor Remote Head Recessed, Black
LLREBZ = Outdoor Remote Head Recessed, Bronze
*Lamps sold separately.
Series
5.38"
(13.67 cm)
1.63"
(4.14 cm)
2.0"
(1.8 cm)
1.8"
(4.57 cm)
MR16 lamp options Description How to Order
12 Volt, 20 Watt, 40° beam spread L12MR20WFL
12 Volt, 35 Watt, 25° beam spread L12MR35FL
12 Volt, 35 Watt, 40° beam spread L12MR35WFL
12 Volt, 50 Watt, 25° beam spread L12MR50FL
12 Volt, 50 Watt, 40° beam spread L12MR50WFL
LP Series
Maximum of 8 luminaires on high setting can be operated by the 50 W C3 Series
Maximum of 13 luminaire son high setting can be operated by the 75 W C3 Series
Consult factory for custom colors.
2.75"
(6.99 cm)
4.5"
(11.4 cm)
1.5"
(3.81 cm)
4.5"
(11.4 cm)
.91"
(2.31 cm)
.78"
(1.98 cm)
2.75"
(6.99 cm)
LP1SBK = Outdoor LED Luminaire, Black
LP1SWH = Outdoor LED Luminaire, White
LP1SIV = Outdoor LED Luminaire, Ivory
LPH1SBK = Outdoor LED Luminaire, Black
LPH1SWH = Outdoor LED Luminaire, White
LPH1SIV = Outdoor LED Luminaire, Ivory
Series
Maximum of 75 W of connected luminaires
can be operated by the C3 Series.
Note
1) Lamp
included per
UL acceptance.
2) UL testing
restricts using
any substitutes
for this lamp
option.