Philips BRP710 User manual

23
83
188
4415 109 22980
IP-65
Installation Instruction
Signify Innovations India Limited
Application : Solar Street Light
Max. Projected Area : 0.411 m²
Lamp : LED (4500, 6000 Lumen)
Voltage : 12.8 V DC
Net Weight : 19 Kg
IP Classification : IP 65
Type : BRP710
Solar Street Luminaire
Dimensions
ta
35
369
511
684
757
805

3Mount the luminaire with the Pole.
1Take the product out of the packing box.
Horizontal Mounting
Vertical Mounting
Pole Dia: to 60mm48
Below mentioned inclinations are possible.
0°,5°,10°,15°.
0°-15°
For accurate angle positioning, marks
are made over the clamping position
of the luminaire. Match the pole
mounting piece marking with luminaire
marking
5°
10°
15°
Tilt the luminaire by rotating it and
open the 4 screws with srew-driver.
5Tilt the luminaire by rotating it and
open the 4 screws with srew-driver.
5Tilt the luminaire by rotating it and
open the 4 screws with srew-driver.
5To switch ON the luminaire Press the
switch button shown in below figure.
Switch
56
7
4
For Vertical Mounting installation
Unscrew the Screw and remove the
pole Mounting Bracket and assemble
it as shown in Fig. B.
7. The Light source of this luminaire is not replaceable; when the
light source reaches its end of life the whole luminaire shall be
replaced.
Luminaire
Protective
Cover
Mounting
Bracket
Shrink
Wrap
Note: Remove Shrink Wrap and Protective
cover before installation.
Fig. A
Fig. B
Note: Tightened the bolts
with torque of 8Nm.
0°
*Note - Representation product images and actual product may vary based on
versions
3 Core Cable
2Pass the wire through the pole and
mount the luminaire
2. Maximum installation height is 5m.
4. After three months of manufacturing it is necessary to check the
glowing of the luminaire, if it is not working then contact to
customer care.
1. This luminaire will not operate below 0 degree ambient.
Precaution:
6. If two red and orange colour LED’s start blinking then first remove
AC input connections and press the switch to switch off the
lumianire and wait for min two minutes. Subsequently follow
same commissioning sequence as per point no. 5
3. Before installation check the luminaire by pressing the switch
and make sure that it is glowing.
5. After installation and during commissioning of luminaire, first
press the switch to switch it ON and then connect AC 230Vrms
input to the luminaire.