Philips PPA1002 User manual

1 / 5
PHILIPS PPA1002

2 / 5
Quick Start Guide

3 / 5
Box content
Please open the package and check the following accessories:
Remote Control Quick start guide

4 / 5
Instructions
nIndicator Light: Press any key and indicator light flashes
[Note] The indicator light will flash quickly when the remote
batteries are low. Please replace the batteries.
nBluetooth Pairing: Pressed the “OK” and “Volume-” keys
together on your Remote Control for 10 seconds
HOME page
Enter/Confirm
Back/Exit
Volume +
Standby On/Off
Volume -
Google Assistant
Navigation pad
APPS
Open Netflix
Open Prime Video
Projector setting

5 / 5
Screeneo Innovation SA
Route de Lully 5C
1131 - Tolochenaz - Switzerland
www.philips.com/welcome
[e-mail]
2020 © Screeneo Innovation SA
All right reserved
FCC: 2ASRT-PPA1002
Philips and the Philips Shield Emblem are registered
trademarks of Koninklijke Philips N.V. used under
license. Screeneo Innovation SA is the warrantor in
relation to the product with which this booklet was
packaged.
Product specification
1.Product is powered by dry battery, Battery specifications AAA 1.5*2
2.Operating temperature 0～50℃
FCC Caution:
Any Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
FCC RF Radiation Exposure Statement:
1. This Transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
2. This equipment complies with RF radiation exposure limits set
forth for an uncontrolled environment.
The device has been evaluated to meet general RF exposure
requirement. The device can be used in portable exposure condition
without restriction.