xx3 - 3
CONNECTION AND CONTROLS
For more information onoperation instruction please visit Philips
Audio internet site :
http://www.audio.philips.com
Press the clip of the black terminal and fully
insert the stripped portion of the black (or
unmarked) speaker cable into the socket, then
release the clip.
BFM antenna
1Extend the wire antenna and move the antenna
in different positions for optimal reception (as far
away as possible from the TV,VCR or other
radiation sources).
2Fix the antenna’s end to the wall.
Rear connections
Warning:
Never make or change connections with
the power supply switched on.
Speakers connection
Use the supplied speakers only. Using other
speakers can damage the set or the sound
quality will be negatively affected.
Connect the speaker wires to the SPEAKERS
terminals, right speaker to “R” and left speaker to
“L”, red (labelled red) wire to “+” and black
(labelled black) wire to “-”.
Red
Black
+
-
Press the clip of the red terminal and fully insert
the stripped portion of the coloured (or
marked) speaker cable into the socket, then
AC power cord
FM wire antenna
Speaker
(right)
Speaker
(left)
12
Red
Black
+-
Using AC power
Make sure all connections have been made
before switching on the power supply.
Connect the power cable supplied to
AC ~ and to the wall socket.This switches on
the power supply.
When the system is switched to standby, it is still
consuming some power. To disconnect the
system from the power supply completely,
remove the power plug from the wall
socket.
The type plate is located on the rear of the
set.
Inserting batteries into the
remote control
Insert two batteries type R06 or AA into the
remote control with the correct polarity as
indicated by the "+" and "-" symbols inside
the battery compartment.
CAUTION!
–Remove batteries if they are
exhausted or will not be used for a
long time.
–Do not use old and new or different
types of batteries in combination.
–Batteries contain chemical
substances, so they should be disposed
off properly.
1
2
3
