Philips Daisy Deluxe FC6068 User manual

Daisy Deluxe Wet/Dry FC6068, FC6067

2

3

4

ENGLISH 6
POLSKI 15
ROMÂNĂ 24
РУССКИЙ 33
ČESKY 43
MAGYAR 51
SLOVENSKY 59
УКРАЇНСЬКІЙ 68
HRVATSKI 77
EESTI 85
LATVISKI 93
LIETUVIŠKAI 101
SLOVENŠČINA 109
FC6068, FC6067
5

Important
◗Read these instructions for use carefully and
look at the illustrations before you start using
the appliance.
◗Always switch the vacuum cleaner off after
use.
◗Never suck up ashes until they are cold.
◗Do not suck up flammable or corrosive
liquids.
◗Do not let water enter the vacuum cleaner or
the wall holder. Never immerse the vacuum
cleaner or the wall holder in water.
◗The charger plug feels warm.This is normal.
◗Only charge the vacuum cleaner with the
charger supplied.
◗Do not use the appliance if it is damaged.Take
it to an authorised Philips service centre for
repair.
Preparing the appliance for use
C◗Wind and store excess mains cord in the wall
holder.
C◗Screw the wall holder to the wall.
◗You can also place the vacuum cleaner and
the wall holder flat on a table during charging.
ENGLISH6

C◗The crevice tool and the squeegee can be
attached to the wall holder by pushing them
into the appropriate fastening slots.
Charging the appliance
1Make sure that the slide switch of the
vacuum cleaner is in off position (0) during
charging.The appliance will not charge if
the slide switch is in another position.
2Insert the charger plug into the wall
socket.
C3Always put the vacuum cleaner back onto
the holder after use.
C◗The indicator light will come on to indicate
that the appliance is charging.
The indicator light will stay on as long as the
appliance is connected to the wall holder and the
plug is in the wall socket.
The indicator light does not give any information
about the charge level of the built-in batteries.
Charge the appliance for at least 16 hours before
you use it for the first time.
Recharge the appliance as soon as the motor
power decreases noticeably.
4Leave the charger plug in the wall socket.
Always place the vacuum cleaner back
ENGLISH 7

onto the holder (also when the built-in
batteries are fully charged).
Vacuum cleaning
1Make sure the deflector and the filter have
been inserted into the dust compartment
before you start using the appliance.
Deflector and filter
C1Press the break button and open the
vacuum cleaner.
C2Insert the deflector and the filter into the
dust compartment.
C3Push the filter firmly into the dust
compartment.
4Close the vacuum cleaner again.
C2Set the slide switch to position I for
normal suction power. Set it to position II
for turbo suction power.
ENGLISH8

Sucking up liquids
C1Connect the squeegee to the dust
compartment.
C2Stop sucking up liquids when the liquid
level inside the dust compartment has
reached the maximum indication line.
C3When sucking up liquids, hold the
appliance with the dust compartment
pointing downwards at an angle. Make sure
the squeegee touches the surfact to be
cleaned. Do not tilt the appliance to one
side.
C4Do not hold the appliance with its dust
compartment pointing upwards, as this
would cause liquid to enter the appliance
and damage the parts inside.
5Empty the dust compartment each time
you have used the appliance to suck up a
liquid.
ENGLISH 9

Connecting accessories
C1Use the crevice tool to vacuum clean
hard-to-reach places.
Do not use the crevice tool to suck up liquids.
Emptying the dust compartment
C1Press the break button and open the
vacuum cleaner over a dustbin.
C2Remove the filter and the deflector from
the dust compartment.
3Clean the filter and empty the dust
compartment.
◗Clean the filter with a brush or with a normal
vacuum cleaner if it is very dirty.
Replacing the filter
C1Remove the deflector and the filter frame
from the dust compartment.
ENGLISH10